Paxar Monarch 415 manual Hub Spindles End Extension Shaft Knob

Page 14

Monarch 415 Rewind Operator’s Handbook

3.Remove the hub sections and replace them with the new ones (Figure 11).

a.Slide the new hub spindle on the shaft. Be sure the notch fits over the raised portion of the hub flange.

b.Slide the hub sections on to the shaft with the open ends facing out. The hub section that fits against the hub spindle has two curved grooves instead of peg holes. Be sure the slot in this section is aligned with the smaller side of the hub spindle. Also be sure the slots in the rest of the hub sections are aligned with this section.

c.Slide the hub end on.

NOTE: For a four or six inch long hub, screw on the extension shaft before you install the hub sections.

d.Screw the hub knob on.

Hub

Spindles

Hub

Hub

End

Extension

Shaft

Hub

Knob

Figure 11

10

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Connecting Supplies Rewinding on the HubMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Operating the Rewind StartingStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications and Supplies SpecificationsTroubleshooting Problem Corrective ActionAppendix a Rewind Alignment Toll Free
Top Page Image Contents