Paxar Monarch 415 manual Label Edge Slot

Page 17

5. Burster Option Setup and Operation

8.Slide the first core onto the 415 hub until it is against the hub flange.

9.Hold the hub flange and twist the hub clockwise until the paper core is tight.

10.Position the slot in the hub to the top.

11.Align the leading edge of the first label on the inside strip with the slot in the hub and tape the supply to the core (Figure 14).

Label Edge

Slot

Figure 14

13

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Rewinding on the Hub Connecting SuppliesMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Starting Operating the RewindStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications Specifications and SuppliesProblem Corrective Action TroubleshootingAppendix a Rewind Alignment Toll Free
Top Page Image Contents