Paxar Monarch 415 manual Burster Option Setup and Operation

Page 15

5.Burster Option Setup and Operation

Proper positioning of the printer, burster, and supplies is critical.

1.Place the Rewind/Burster assembly in the proper position in front of the printer. A drawing showing the correct position for all supported printers and optional location guides for alignment is inside the back cover.

2.Print or feed approximately 36 inches of labels from the printer.

3.Bend and separate the supply along the perforations into individual strips for about 18 inches (Figure 12).

Figure 12

11

Image 15
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Rewinding on the Hub Connecting SuppliesMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Starting Operating the RewindStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications Specifications and SuppliesProblem Corrective Action TroubleshootingAppendix a Rewind Alignment Toll Free