Paxar Monarch 415 manual Changing Hubs

Page 13

4. Changing Hubs

If you change to a different supply, you may need to use a different hub. One, three, and four inch diameter hubs (short and long) are available from Monarch.

To change hubs

1.Pull the supply guide away from the hub (Figure 9).

Supply

Guide

Figure 9

2.Unscrew the hub knob (Figure 10).

NOTE: The hub diameter must be the same as the inside diameter of the supplies.

Hub

Knob

Hub

Sections

Figure 10

9

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Rewinding on the Hub Connecting SuppliesMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Starting Operating the RewindStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications Specifications and SuppliesProblem Corrective Action TroubleshootingAppendix a Rewind Alignment Toll Free
Top Page Image Contents