Paxar Monarch 415 manual Separator Bars

Page 16

Monarch 415 Rewind Operator’s Handbook

4.Figure 13 shows the burster with the supplies installed. Place the separator bars in their approximate working positions (i.e. in line with the perforations). When only one bar is needed (for two part supply), slide unused bar to the outboard side.

Separator

Bars

Figure 13

5.Thread the inner strip of supplies under the dancer arm roller, behind the two lower burster shafts, and in front of the top shaft.

6.Thread the middle strip under the dancer arm roller, behind the lower burster shaft, and in front of the two top shafts.

7.Thread the outer strip under the dancer arm roller, behind the two lower burster shafts, and in front of the top shaft.

12

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Connecting Supplies Rewinding on the HubMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Operating the Rewind StartingStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications and Supplies SpecificationsTroubleshooting Problem Corrective ActionAppendix a Rewind Alignment Toll Free
Top Page Image Contents