Paxar manual Monarch 415 Rewind Operator’s Handbook

Page 8

Monarch 415 Rewind Operator’s Handbook

6.Turn the hub and hub flange at least one full turn counterclockwise to tighten the supply strip.

7.Push the supply guide against the hub then slide it against the supply.

NOTE: Units with 3" hubs have a flanged disk instead of a supply guide.

Slide this disk over the hub and against the stock/core (Figure 4).

Figure 4

4

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Connecting Supplies Rewinding on the HubMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Operating the Rewind StartingStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications and Supplies SpecificationsTroubleshooting Problem Corrective ActionAppendix a Rewind Alignment Toll Free
Top Page Image Contents