Paxar Monarch 415 manual Label Edges Separator Bars

Page 22

Monarch 415 Rewind Operator’s Handbook

20.Recheck the printer to rewind alignment and fine adjust as necessary.

21.Verify that the separator bars are located between the strip as shown in Figure 19.

22.Verify that the labels on all three strips are aligned.

NOTE: All labels must be aligned as though the supply was never separated to prevent torn strips or labels coming off.

Label

Edges

Separator

Bars

Figure 19

23.Turn the flange counterclockwise to take up any slack in the strips.

24.Set the speed control knob to SLOW.

25.Turn on the rewind, operate the printer, and increase the speed if necessary.

18

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Connecting Supplies Rewinding on the HubMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Operating the Rewind StartingStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications and Supplies SpecificationsTroubleshooting Problem Corrective ActionAppendix a Rewind Alignment Toll Free
Top Page Image Contents