Paxar Monarch 415 manual Setting Up

Page 5

1. Setting Up

1.Push the 415 Rewind power switch OFF.

2.Place the rewind on a level surface. Be sure it is at least ten inches away from the supply exit of the printer (Figure 1).

3.Squarely align the rewind’s hub flange with the edge of the supply. See Appendix A, "Rewind Alignment."

Hub

Flange

 

Printer

 

Supply

Hub

Exit

 

Power

Switch

Figure 1

1

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Rewinding on the Hub Connecting SuppliesMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Starting Operating the RewindStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications Specifications and SuppliesProblem Corrective Action TroubleshootingAppendix a Rewind Alignment Toll Free
Top Page Image Contents