Paxar Monarch 415 manual Connecting Supplies, Rewinding on the Hub

Page 7

2. Connecting Supplies

Rewinding on the Hub

1.Slide the supply guide away from the hub flange and pull it away from the hub.

2.Print or feed enough supplies from the printer to wrap around the hub one and one half times.

3.Hold the hub flange and twist the hub clockwise until it stops.

4.Thread the supply strip under the dancer roller.

5.Fold and insert the end of the supply strip into the slot (Figure 3). Be sure the supply is against the hub flange.

Supply

HubStrip

Flange

Slot

Dancer

Supply

Guide

 

Roller

 

 

Figure 3

 

3

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Rewinding on the Hub Connecting SuppliesMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Starting Operating the RewindStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications Specifications and SuppliesProblem Corrective Action TroubleshootingAppendix a Rewind Alignment Toll Free
Top Page Image Contents