Paxar 9854, 9844 manual Printer Contents, Removing the Transportation Lock

05/08 Rev. AB		OPERATOR’S HANDBOOK	Getting Started	1-3
		9844/9854
		Printer Contents
		After you unpack your printer, make sure you have all the necessary
		components and that the printer was not damaged during shipping.
	•	Printer
	•	Power supply cable
		The plug for the power supply is different depending on the country of
		delivery.
	•	Data cable
		Centronics IEEE 1284 CA Cable 2 m.
	•	Core adapters
		There are two core adapters each for the material rolls with a internal core
		diameter of 3 inches (76mm) and 4 inches (101 mm). The core adapters are
		placed on the printer material dispenser.
	•	Empty foil core
		For rewinding the ribbon (foil). The backing paper is placed on foil rewind
		reel.
	•	Operator’s Handbook
	•	Size 10 Torx screwdriver
		Used to replace the print roller and add a dispensing (peel) edge.
9854 with	•	9854 printer with installed deflector
Internal Liner	•	Housing front part, bottom side with screw (Fig. 3 right side)
Takeup Reel		Use the housing parts if the printer does not have the internal liner takeup
		reel (rewinder).

	Fig. 3: These housing parts are shipped loose with the printer with internal liner takeup.
	Removing the Transportation Lock
1.	Open the cover.
2.	Remove the two foam pads holding the printhead in place.
9854 with	Remove the connector from its transport position at the printer bottom and
Dispenser	connect it to the front of the printer.