Paxar 9844 manual Dispensing Peel 9854 only

05/08 Rev. AB OPERATOR’S HANDBOOK Setup 2-10

9844/9854

Dispensing (Peel) 9854 only

1.Follow the steps for loading material from the previous section. Then, follow these steps.

2.Remove the labels from the first 10 inches (25 mm) of backing paper (Fig. 1).

3.Press the red button (1) at the dispensing edge to release the peel roller (Fig. 1).

4.Remove the peel roller, feed the label web through as illustrated (Fig. 1) and press the roller back between its bearings.

5.Thread the backing paper backwards to the takeup reel (2) as shown (fig. 2).

6.Wrap the end of the backing paper clockwise around the takeup reel (2) and secure it with the clip (3).

7.Turn the takeup reel counter-clockwise until the backing paper is pulled tight.

After turning on the printer, the reel rotates slowly until the material web is pulled tight (Fig. 3).

You may see

Status5004 Rewinder mat. tear

before the material is pulled tight.

If this happens, press Online to clear the message. You may need to press it several times.

1

™

2 š

›

3