Paxar 9854, 9844 manual Using Compact Flash Cards, Inserting a CF card

Page 27

05/08 Rev. AB	OPERATOR’S HANDBOOK	Getting Started		1-19
	9844/9854			1-19
	9844/9854
Compact Flash	You need the following to load a print job from a Compact Flash card:
Card	• a 9854 printer

•a Compact Flash card (copy the print job to the \FORMATS directory)

•a computer with a PCMCIA drive and

•an adapter for the Compact Flash card.

Rename the print job file on the Compact Flash card to autostrt.for so the printer recognizes it. Once this is finished, the printer completes the print job as soon as it is set to online mode.

Using Compact Flash Cards

CAUTION! - Only use approved Compact Flash cards (order number 160002).

CAUTION! - Wait five seconds after turning off the printer before removing or inserting the Compact Flash card!

The printer firmware cannot use more than 128 MB of card storage capacity.

Slim guide notch		Wide guide notch

Fig. 11: Example of a 32MB Compact Flash card.

Inserting a CF card

1.Turn off the printer. Wait five seconds.

2.Insert the Compact Flash card completely into the card slot. The wide guide notch should face upwards (see Fig. 12).

Push the Compact Flash card into the slot until the release button (1) comes out. The card sits flush with the back wall.

Fig. 12: Inserting a Compact Flash card into a 9854 printer. If the Compact Flash card is inserted correctly, it sits flush with the printer’s back wall (right).

Image 27

Contents Operators Handbook Copyright Safety Information Service General safety notesEquipment safety Battery Disposal Information Disposal ProceduresCanadian D.O.C. Warning FCC Regulations Class BTable of Contents Getting Started Installing the Printer Unpacking the printerCarrying the Printer Removing the Transportation Lock Printer ContentsTerms to Know Exterior view of the printer About the PrinterTakeup Peel and LinerAbout the 9854 Dispenser Peel and Internal Liner Takeup Dispenser Mode with Dispensing Edge SensorIdentifying Printer Connections Start/stop signal input Serial InterfaceSafety Information Using the Control Panel Display Offline Mode Online ModeOperating Modes Standalone ModeOnly Connecting the Printer Using the PrinterEnable Setting the InterfaceUsing the 9854 Printer with Internal Liner Takeup DisableParameter Possible Settings Using the 9854 Printer with DispenserLabel length ConfiguringOffline Operation PositionPrint Info Online OperationPrinter Driver Creating a Print jobSending a Print Job WindowsInserting a CF card Using Compact Flash CardsCompact Flash CardOutputting the realtime clock value using Easy Plug Setting the Realtime Clock 9854 onlySetup Material and ribbon path in printer Loading DiagramsPrinter with Internal Liner Takeup Reel Rewinder Material and ribbon path through printer with dispenser peel Printer with Dispenser PeelSelecting Ribbon/Material About MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Replacing a used ribbon Loading a RibbonQuick ribbon exchange Material/Ribbon End Material Stock EndRibbon End Adjusting wheel for the printhead support Setting Printhead SupportParameter Setting the Material ParametersOPERATOR’S Handbook Care & Maintenance Calling Technical Support Frequency of Care Care & MaintenanceSafety TroubleshootingCleaning the Printhead Cleaning with the cleaning pen order part numberCleaning with isopropyl alcohol Connecting the printhead Replacing the PrintheadRemoving the printhead ™ š Cleaning the Print RollerCleaning the Punch Die Cut Sensor Specifications Printers SpecificationsRibbon Foil Supplies MaterialSpecifications Page Toll Free