Paxar 9844, 9854 manual Care & Maintenance, Safety, Troubleshooting

Page 46

05/08 Rev. AB

OPERATOR’S HANDBOOK

Care & Maintenance

 

3-2

 

9844/9854

 

 

 

 

 

 

 

 

 

 

Care & Maintenance

Regular maintenance is required to make sure the printer is always operating safely.

Safety

WARNING!

Maintenance and cleaning may result in hazardous situations. Accidents can occur if safety instructions are not followed!

Turn off the printer and disconnect the power supply before any cleaning or maintenance work!

Do not spill liquid into the printer!

Do not spray any cleaner directly on the printer! Moisten a cloth with the recommended cleaning agent to clean the printer!

Troubleshooting

Error Messages When an error occurs, read the messages first and refer to the documentation for more information.

Calling

Technical

Support

Frequency of Care

If you need to call Service, have your printer’s model number and serial number ready.

Call Service to order spare parts.

Note on Cleaning

Frequent maintenance and cleaning is required to make sure the printer is operating properly. The rate and frequency at which you print determine how often you must clean the printer.

Frequently check the printhead and feed rollers for paper or adhesive buildup.

WARNING! - Do not use any cleaning agent that could damage or destroy the resin surface, labelling, display, nameplates, electrical components, etc.

WARNING! - Do not use any cleaning agents that are abrasive or damaging to plastics. Avoid acid or alkaline solutions.

Image 46
Contents Operators Handbook Copyright Safety Information General safety notes ServiceEquipment safety Disposal Procedures Battery Disposal InformationFCC Regulations Class B Canadian D.O.C. WarningTable of Contents Getting Started Unpacking the printer Installing the PrinterCarrying the Printer Printer Contents Removing the Transportation LockTerms to Know About the Printer Exterior view of the printerPeel and Liner TakeupDispenser Mode with Dispensing Edge Sensor About the 9854 Dispenser Peel and Internal Liner TakeupStart/stop signal input Serial Interface Identifying Printer ConnectionsSafety Information Using the Control Panel Display Online Mode Offline ModeOperating Modes Mode StandaloneOnly Using the Printer Connecting the PrinterDisable Setting the InterfaceUsing the 9854 Printer with Internal Liner Takeup EnableUsing the 9854 Printer with Dispenser Parameter Possible SettingsPosition ConfiguringOffline Operation Label lengthOnline Operation Print InfoWindows Creating a Print jobSending a Print Job Printer DriverCard Using Compact Flash CardsCompact Flash Inserting a CF cardSetting the Realtime Clock 9854 only Outputting the realtime clock value using Easy PlugSetup Loading Diagrams Material and ribbon path in printerPrinter with Internal Liner Takeup Reel Rewinder Printer with Dispenser Peel Material and ribbon path through printer with dispenser peelAbout Material Selecting Ribbon/MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Loading a Ribbon Replacing a used ribbonQuick ribbon exchange Material Stock End Material/Ribbon EndRibbon End Setting Printhead Support Adjusting wheel for the printhead supportSetting the Material Parameters ParameterOPERATOR’S Handbook Care & Maintenance Troubleshooting Care & MaintenanceSafety Calling Technical Support Frequency of CareCleaning with the cleaning pen order part number Cleaning the PrintheadCleaning with isopropyl alcohol Replacing the Printhead Connecting the printheadRemoving the printhead Cleaning the Print Roller ™ šCleaning the Punch Die Cut Sensor Specifications Specifications PrintersSupplies Material Ribbon FoilSpecifications Page Toll Free