Paxar 9854, 9844 manual Material/Ribbon End, Material Stock End

Page 41

05/08 Rev. AB	OPERATOR’S HANDBOOK	Setup		2-13
	9844/9854			2-13
	9844/9854

Material/Ribbon End

Material Stock End

If the material end has passed the material sensor, you see

Status5002 Material end

Release the pressure lever and pull the end of the remaining material from the front side of the printer.

Ribbon End

If the ribbon roll is emptied (the ribbon unwind reel is not turning), you see

Status5008

Ribbon end

See “Loading a Ribbon” to continue.

Ribbon end detection can be turned off for theromodirect printing.

To do so, set the parameter SYSTEM PARAMETERS > Ribbon autoecon. to

Thermal printing.

PRefer to the “Info-Printouts and Parameters” section on your CD-ROM for more information.

Image 41

Contents Operators Handbook Copyright Safety Information Service General safety notesEquipment safety Battery Disposal Information Disposal ProceduresCanadian D.O.C. Warning FCC Regulations Class BTable of Contents Getting Started Carrying the Printer Installing the PrinterUnpacking the printer Removing the Transportation Lock Printer ContentsTerms to Know Exterior view of the printer About the PrinterTakeup Peel and LinerAbout the 9854 Dispenser Peel and Internal Liner Takeup Dispenser Mode with Dispensing Edge SensorIdentifying Printer Connections Start/stop signal input Serial InterfaceSafety Information Using the Control Panel Display Operating Modes Offline ModeOnline Mode Only StandaloneMode Connecting the Printer Using the PrinterUsing the 9854 Printer with Internal Liner Takeup Setting the InterfaceDisable EnableParameter Possible Settings Using the 9854 Printer with DispenserOffline Operation ConfiguringPosition Label lengthPrint Info Online OperationSending a Print Job Creating a Print jobWindows Printer DriverCompact Flash Using Compact Flash CardsCard Inserting a CF cardOutputting the realtime clock value using Easy Plug Setting the Realtime Clock 9854 onlySetup Material and ribbon path in printer Loading DiagramsPrinter with Internal Liner Takeup Reel Rewinder Material and ribbon path through printer with dispenser peel Printer with Dispenser PeelAbout Ribbons Selecting Ribbon/MaterialAbout Material Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Replacing a used ribbon Loading a RibbonQuick ribbon exchange Ribbon End Material/Ribbon EndMaterial Stock End Adjusting wheel for the printhead support Setting Printhead SupportParameter Setting the Material ParametersOPERATOR’S Handbook Care & Maintenance Safety Care & MaintenanceTroubleshooting Calling Technical Support Frequency of CareCleaning with isopropyl alcohol Cleaning the PrintheadCleaning with the cleaning pen order part number Removing the printhead Connecting the printheadReplacing the Printhead ™ š Cleaning the Print RollerCleaning the Punch Die Cut Sensor Specifications Printers SpecificationsRibbon Foil Supplies MaterialSpecifications Page Toll Free