Paxar 9854, 9844 manual Setting the Material Parameters

Page 43

05/08 Rev. AB

OPERATOR’S HANDBOOK

Setup

2-15

 

 

 

9844/9854

Setting the Material Parameters

Use the following three parameters to set the material properties:

Parameter

PRINT PARAMETERS/ Material type

PRINT PARAMETERS/ Material length

PRINT PARAMETERS/ Material width

SYSTEM PARAMETERS/ Light sens

. type

Function

Sets the material type (perforated or endless)

Sets the material length

Sets the material width

Sets the sensor type (reflex or transmission) based on the material (marks or perforations)

Tab. 1:Important parameters for setting the material properties.

PRefer to the “Info-Printouts and Parameters” section on your CD-ROM for more information on setting parameters.

Image 43
Contents Operators Handbook Copyright Safety Information Service General safety notesEquipment safety Battery Disposal Information Disposal ProceduresCanadian D.O.C. Warning FCC Regulations Class BTable of Contents Getting Started Unpacking the printer Installing the PrinterCarrying the Printer Removing the Transportation Lock Printer ContentsTerms to Know Exterior view of the printer About the PrinterTakeup Peel and LinerAbout the 9854 Dispenser Peel and Internal Liner Takeup Dispenser Mode with Dispensing Edge SensorIdentifying Printer Connections Start/stop signal input Serial InterfaceSafety Information Using the Control Panel Display Online Mode Offline ModeOperating Modes Mode StandaloneOnly Connecting the Printer Using the PrinterEnable Setting the InterfaceUsing the 9854 Printer with Internal Liner Takeup DisableParameter Possible Settings Using the 9854 Printer with DispenserLabel length ConfiguringOffline Operation PositionPrint Info Online OperationPrinter Driver Creating a Print jobSending a Print Job WindowsInserting a CF card Using Compact Flash CardsCompact Flash CardOutputting the realtime clock value using Easy Plug Setting the Realtime Clock 9854 onlySetup Material and ribbon path in printer Loading DiagramsPrinter with Internal Liner Takeup Reel Rewinder Material and ribbon path through printer with dispenser peel Printer with Dispenser PeelAbout Material Selecting Ribbon/MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Replacing a used ribbon Loading a RibbonQuick ribbon exchange Material Stock End Material/Ribbon EndRibbon End Adjusting wheel for the printhead support Setting Printhead SupportParameter Setting the Material ParametersOPERATOR’S Handbook Care & Maintenance Calling Technical Support Frequency of Care Care & MaintenanceSafety TroubleshootingCleaning with the cleaning pen order part number Cleaning the PrintheadCleaning with isopropyl alcohol Replacing the Printhead Connecting the printheadRemoving the printhead ™ š Cleaning the Print RollerCleaning the Punch Die Cut Sensor Specifications Printers SpecificationsRibbon Foil Supplies MaterialSpecifications Page Toll Free