05/08 Rev. AB | OPERATOR’S HANDBOOK | Setup |
| |
| 9844/9854 |
| ||
|
|
|
|
Setting Printhead Support
When printing narrow labels, the printhead may come into contact with the print roller where there is no material. This can lead to premature wear of the printhead and to different print intensity between the two edges of the label.
When using narrow labels, enable the printhead support. Small = material width < printhead width.
Change the printhead support by using the adjusting wheel (1). Position 0 is recommended for wide labels.
Fig. 1: The adjusting wheel for the printhead support.
1.For narrow labels, turn the adjusting wheel clockwise until the pointer indicates 1 on the dial. This causes the printhead to be raised at the outside.
2.Print a test print and check for even print quality. If the print quality is still uneven, turn the adjusting wheel a little further.
3.Repeat steps 1 to 3 until the print quality is the same across the entire width of the label.