Paxar 9844 manual Loading the 9854 with Internal Liner Takeup Reel

Page 37

05/08 Rev. AB

OPERATOR’S HANDBOOK

Setup

2-9

 

 

 

9844/9854

Loading the 9854 with the

Internal Liner Takeup Reel

1.Follow the steps for loading material from the previous section. Then, follow these steps.

2. Thread the end of the material to the

1

internal liner takeup reel (1) as shown and

 

secure it with the clip (2) (Fig. 1).

 

3.Choose the rotation direction of the takeup reel (face inside or outside): Select parameter REWINDER PARA > Rewind direction.

After turning on the printer, the takeup reel rotates slowly until the material is pulled tight.

You may see

Status5004 Rewinder mat. tear

before the material is pulled tight.

If this happens, press Online to clear the message. You may have to press it several times.

™

š

Image 37
Contents Operators Handbook Copyright Safety Information Service General safety notesEquipment safety Battery Disposal Information Disposal ProceduresCanadian D.O.C. Warning FCC Regulations Class BTable of Contents Getting Started Unpacking the printer Installing the PrinterCarrying the Printer Removing the Transportation Lock Printer ContentsTerms to Know Exterior view of the printer About the PrinterTakeup Peel and LinerAbout the 9854 Dispenser Peel and Internal Liner Takeup Dispenser Mode with Dispensing Edge SensorIdentifying Printer Connections Start/stop signal input Serial InterfaceSafety Information Using the Control Panel Display Online Mode Offline ModeOperating Modes Mode StandaloneOnly Connecting the Printer Using the PrinterUsing the 9854 Printer with Internal Liner Takeup Setting the InterfaceDisable EnableParameter Possible Settings Using the 9854 Printer with DispenserOffline Operation ConfiguringPosition Label lengthPrint Info Online OperationSending a Print Job Creating a Print jobWindows Printer DriverCompact Flash Using Compact Flash CardsCard Inserting a CF cardOutputting the realtime clock value using Easy Plug Setting the Realtime Clock 9854 onlySetup Material and ribbon path in printer Loading DiagramsPrinter with Internal Liner Takeup Reel Rewinder Material and ribbon path through printer with dispenser peel Printer with Dispenser PeelAbout Material Selecting Ribbon/MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Replacing a used ribbon Loading a RibbonQuick ribbon exchange Material Stock End Material/Ribbon EndRibbon End Adjusting wheel for the printhead support Setting Printhead SupportParameter Setting the Material ParametersOPERATOR’S Handbook Care & Maintenance Safety Care & MaintenanceTroubleshooting Calling Technical Support Frequency of CareCleaning with the cleaning pen order part number Cleaning the PrintheadCleaning with isopropyl alcohol Replacing the Printhead Connecting the printheadRemoving the printhead ™ š Cleaning the Print RollerCleaning the Punch Die Cut Sensor Specifications Printers SpecificationsRibbon Foil Supplies MaterialSpecifications Page Toll Free