Paxar 9844, 9854 manual Loading Material

Page 34

05/08 Rev. AB	OPERATOR’S HANDBOOK
	9844/9854

Loading Material

WARNING!

Rotating axles! – Keep long hair, loose clothing, jewelry, etc. away from the printer!

Do not operate the printer with the cover open!

Be careful when touching the printhead. It may be hot.

The printer can use both roll and fan-fold material. Follow these steps to load material.

PSee “Specifications” for more information about the media.

1. Open the cover.

1

2.Release the printhead pressure lever (1).

3.Remove the external guide plate (2) from the material roller.

4.Push the material roll onto the correctly sized adapter disc (3) on the unwinder. Push the guide plate back on.

The material roll turns counter- clockwise when unwinding!

5. Insert the material as shown (Fig. 2).		2
5. Insert the material as shown (Fig. 2).		2
Be sure to thread the material around
the material tension roller (4) as well!

Setup 2-6

Image 34

Contents Operators Handbook Copyright Safety Information General safety notes ServiceEquipment safety Disposal Procedures Battery Disposal InformationFCC Regulations Class B Canadian D.O.C. WarningTable of Contents Getting Started Unpacking the printer Installing the PrinterCarrying the Printer Printer Contents Removing the Transportation LockTerms to Know About the Printer Exterior view of the printerPeel and Liner TakeupDispenser Mode with Dispensing Edge Sensor About the 9854 Dispenser Peel and Internal Liner TakeupStart/stop signal input Serial Interface Identifying Printer ConnectionsSafety Information Using the Control Panel Display Online Mode Offline ModeOperating Modes Mode StandaloneOnly Using the Printer Connecting the PrinterDisable Setting the InterfaceUsing the 9854 Printer with Internal Liner Takeup EnableUsing the 9854 Printer with Dispenser Parameter Possible SettingsPosition ConfiguringOffline Operation Label lengthOnline Operation Print InfoWindows Creating a Print jobSending a Print Job Printer DriverCard Using Compact Flash CardsCompact Flash Inserting a CF cardSetting the Realtime Clock 9854 only Outputting the realtime clock value using Easy PlugSetup Loading Diagrams Material and ribbon path in printerPrinter with Internal Liner Takeup Reel Rewinder Printer with Dispenser Peel Material and ribbon path through printer with dispenser peelAbout Material Selecting Ribbon/MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Loading a Ribbon Replacing a used ribbonQuick ribbon exchange Material Stock End Material/Ribbon EndRibbon End Setting Printhead Support Adjusting wheel for the printhead supportSetting the Material Parameters ParameterOPERATOR’S Handbook Care & Maintenance Troubleshooting Care & MaintenanceSafety Calling Technical Support Frequency of CareCleaning with the cleaning pen order part number Cleaning the PrintheadCleaning with isopropyl alcohol Replacing the Printhead Connecting the printheadRemoving the printhead Cleaning the Print Roller ™ šCleaning the Punch Die Cut Sensor Specifications Specifications PrintersSupplies Material Ribbon FoilSpecifications Page Toll Free