Paxar 9844, 9854 manual Loading Fan-fold Material

Page 36

05/08 Rev. AB	OPERATOR’S HANDBOOK	Setup		2-8
	9844/9854			2-8
	9844/9854

Loading Fan-fold Material

Follow these steps to load fan-fold material:

1.Open the cover.

2.Release the printhead pressure lever (1).

3.Position the fan-folded material behind the printer (Fig. 1).

4.Guide the material over the material unwinder. Push the material guide up to the edge of the material without pinching the material.

5.Slide the light barrier fitting using the grip

(6) until the pointer (7) is located above the material perforations (Fig. 2).

The optional reflex sensor is located 5mm to the right of the pointer below the material!

6.Thermodirect printing: Close the pressure

lever. Thermotransfer printing: See “Loading Ribbon” to continue.

1

2

Image 36

Contents Operators Handbook Copyright Safety Information General safety notes ServiceEquipment safety Disposal Procedures Battery Disposal InformationFCC Regulations Class B Canadian D.O.C. WarningTable of Contents Getting Started Installing the Printer Unpacking the printerCarrying the Printer Printer Contents Removing the Transportation LockTerms to Know About the Printer Exterior view of the printerPeel and Liner TakeupDispenser Mode with Dispensing Edge Sensor About the 9854 Dispenser Peel and Internal Liner TakeupStart/stop signal input Serial Interface Identifying Printer ConnectionsSafety Information Using the Control Panel Display Offline Mode Online ModeOperating Modes Standalone ModeOnly Using the Printer Connecting the PrinterSetting the Interface Using the 9854 Printer with Internal Liner TakeupDisable EnableUsing the 9854 Printer with Dispenser Parameter Possible SettingsConfiguring Offline OperationPosition Label lengthOnline Operation Print InfoCreating a Print job Sending a Print JobWindows Printer DriverUsing Compact Flash Cards Compact FlashCard Inserting a CF cardSetting the Realtime Clock 9854 only Outputting the realtime clock value using Easy PlugSetup Loading Diagrams Material and ribbon path in printerPrinter with Internal Liner Takeup Reel Rewinder Printer with Dispenser Peel Material and ribbon path through printer with dispenser peelSelecting Ribbon/Material About MaterialAbout Ribbons Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Loading a Ribbon Replacing a used ribbonQuick ribbon exchange Material/Ribbon End Material Stock EndRibbon End Setting Printhead Support Adjusting wheel for the printhead supportSetting the Material Parameters ParameterOPERATOR’S Handbook Care & Maintenance Care & Maintenance SafetyTroubleshooting Calling Technical Support Frequency of CareCleaning the Printhead Cleaning with the cleaning pen order part numberCleaning with isopropyl alcohol Connecting the printhead Replacing the PrintheadRemoving the printhead Cleaning the Print Roller ™ šCleaning the Punch Die Cut Sensor Specifications Specifications PrintersSupplies Material Ribbon FoilSpecifications Page Toll Free