Paxar 9844, 9854 manual Cleaning the Punch Die Cut Sensor

Page 50

05/08 Rev. AB	OPERATOR’S HANDBOOK	Care & Maintenance		3-6
	9844/9854			3-6
	9844/9854

Cleaning the Punch (Die Cut) Sensor

During printing, the punch sensor can become contaminated with lint and unable to sense material.

1.Remove the cover (1) gently and swivel downwards (Fig. 1).

2.Remove the sensor arm (2) (Fig. 2).

3.Clean the opening (3) with compressed air.

1

The transmission sensor is located in the upper and the lower part of the sensor arm on a level with the indicator (4). You can find the reflex sensor about 5 mm further below.

CAUTION! - The sensor surface is very sensitive to scratches!

Do not use sharp objects or solvents when cleaning the sensors.

2

Image 50

Contents Operators Handbook Copyright Safety Information General safety notes ServiceEquipment safety Disposal Procedures Battery Disposal InformationFCC Regulations Class B Canadian D.O.C. WarningTable of Contents Getting Started Carrying the Printer Installing the PrinterUnpacking the printer Printer Contents Removing the Transportation LockTerms to Know About the Printer Exterior view of the printerPeel and Liner TakeupDispenser Mode with Dispensing Edge Sensor About the 9854 Dispenser Peel and Internal Liner TakeupStart/stop signal input Serial Interface Identifying Printer ConnectionsSafety Information Using the Control Panel Display Operating Modes Offline ModeOnline Mode Only StandaloneMode Using the Printer Connecting the PrinterDisable Setting the InterfaceUsing the 9854 Printer with Internal Liner Takeup EnableUsing the 9854 Printer with Dispenser Parameter Possible SettingsPosition ConfiguringOffline Operation Label lengthOnline Operation Print InfoWindows Creating a Print jobSending a Print Job Printer DriverCard Using Compact Flash CardsCompact Flash Inserting a CF cardSetting the Realtime Clock 9854 only Outputting the realtime clock value using Easy PlugSetup Loading Diagrams Material and ribbon path in printerPrinter with Internal Liner Takeup Reel Rewinder Printer with Dispenser Peel Material and ribbon path through printer with dispenser peelAbout Ribbons Selecting Ribbon/MaterialAbout Material Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Loading a Ribbon Replacing a used ribbonQuick ribbon exchange Ribbon End Material/Ribbon EndMaterial Stock End Setting Printhead Support Adjusting wheel for the printhead supportSetting the Material Parameters ParameterOPERATOR’S Handbook Care & Maintenance Troubleshooting Care & MaintenanceSafety Calling Technical Support Frequency of Care Cleaning with isopropyl alcohol Cleaning the Printhead Cleaning with the cleaning pen order part number Removing the printhead Connecting the printheadReplacing the Printhead Cleaning the Print Roller ™ šCleaning the Punch Die Cut Sensor Specifications Specifications PrintersSupplies Material Ribbon FoilSpecifications Page Toll Free