Paxar 9854, 9844 manual

Page 35

05/08 Rev. AB	OPERATOR’S HANDBOOK	Setup	2-7
			2-7

9844/9854

6.Push the material guide (5) up to the edge of the material, without pinching the material (Fig. 3).

7.Slide the light barrier fitting using the grip

(6) until the pointer (7) is located above the material perforations (Fig. 4).

The optional reflex sensor is located 5mm to the right of the pointer below the material!

8.Thermodirect printing: Close the pressure

lever. Thermotransfer printing: See “Loading Ribbon” to continue.

3

4

Image 35

Contents Operators Handbook Copyright Safety Information Service General safety notesEquipment safety Battery Disposal Information Disposal ProceduresCanadian D.O.C. Warning FCC Regulations Class BTable of Contents Getting Started Carrying the Printer Installing the PrinterUnpacking the printer Removing the Transportation Lock Printer ContentsTerms to Know Exterior view of the printer About the PrinterTakeup Peel and LinerAbout the 9854 Dispenser Peel and Internal Liner Takeup Dispenser Mode with Dispensing Edge SensorIdentifying Printer Connections Start/stop signal input Serial InterfaceSafety Information Using the Control Panel Display Operating Modes Offline ModeOnline Mode Only StandaloneMode Connecting the Printer Using the PrinterEnable Setting the InterfaceUsing the 9854 Printer with Internal Liner Takeup DisableParameter Possible Settings Using the 9854 Printer with DispenserLabel length ConfiguringOffline Operation PositionPrint Info Online OperationPrinter Driver Creating a Print jobSending a Print Job WindowsInserting a CF card Using Compact Flash CardsCompact Flash CardOutputting the realtime clock value using Easy Plug Setting the Realtime Clock 9854 onlySetup Material and ribbon path in printer Loading DiagramsPrinter with Internal Liner Takeup Reel Rewinder Material and ribbon path through printer with dispenser peel Printer with Dispenser PeelAbout Ribbons Selecting Ribbon/MaterialAbout Material Loading Material Ÿ ž Loading Fan-fold Material Loading the 9854 with Internal Liner Takeup Reel Dispensing Peel 9854 only Replacing a used ribbon Loading a RibbonQuick ribbon exchange Ribbon End Material/Ribbon EndMaterial Stock End Adjusting wheel for the printhead support Setting Printhead SupportParameter Setting the Material ParametersOPERATOR’S Handbook Care & Maintenance Calling Technical Support Frequency of Care Care & MaintenanceSafety TroubleshootingCleaning with isopropyl alcohol Cleaning the PrintheadCleaning with the cleaning pen order part number Removing the printhead Connecting the printheadReplacing the Printhead ™ š Cleaning the Print RollerCleaning the Punch Die Cut Sensor Specifications Printers SpecificationsRibbon Foil Supplies MaterialSpecifications Page Toll Free