Keyboard command usage
When using keyboard commands to enter information to the UltraView Pro, please observe the following guidelines to avoid entering incorrect values or no values.
1.All commands start with a press and release of the left control key.
2.Commands following the press and release of the left control key must be entered within 2 seconds or control reverts to the connected computer and the command will be sent to that computer and not the UltraView Pro.
3.Use only the numeric keys above the keyboard and not the numeric keypad.
4.Letter commands such as <Ctrl> L are not case sensitive and are only shown in uppercase for clarity. Do not use the shift key to enter letter commands.
5.To connect to the next or previous computer, the keyboard command is <Ctrl> + or <Ctrl>
Reset to factory defaults
To reset the UltraView Pro to the original factory default settings, first, power down the unit, press and hold the – (minus) switch in and turn the power on to the unit. Keep the – (minus) switch held in until the unit switches to the last port on the unit (port 4, 8, or 16). If you release the – (minus) switch before the last port is switched to, the defaults will not be restored. The configuration and access passwords are not reset using this procedure.
Rackmounting
The UltraView Pro can be rack mounted using a Rose Electronics Rackmount kit. See Appendix D and E for instructions.
ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL | 29 |
|
|