Orion Car Audio 1892 1335 manual Telemetry Option Configuration, Analogue In Set-up

Page 19

Telemetry Option Configuration

Depending on which mode you are using the Orion unit in, you may need to set up other options such as alarm levels.

vThese options are not relevant if you are using the unit as a straight modem.

Analogue Input Setup

Figure 15 - Analogue In Set-up
For each input, select:
Type:	20mA input
	0 to +5V input
	0 to 10V input
Alarm threshold:	1 to 1023 - proportion of full scale (0 = never alarm)
Alarm validation period:	1 to 255 - time for which condition must persist (in 10ms
	blocks)
Alarm condition:	Greater than or less than threshold level

Digital Input Setup

Figure 16 - Digital In Set-up

1892 1335 - Orion Radio Modem Operating Instructions - v1.3 / Aug 2006

19

Image 19

Contents Orion Radio Modem Orion Radio Modem with I/O Operating InstructionsOverview Shows the Orion in block diagram formPage Options When Ordering Physical InstallationDimensions of Orion PCB mm RJ45 Port Pin No Digital Digital Out Analogue Analogue Out ConnectionsTXB Pin No RS232 RS422 RS485Graphical User Interface GUI Hardware Link Settings Setting UP AN OrionOption Choice Links Using the GUIPage COM Ports and General Status Modem Modes TMR TNT TMX TNX TOM TOS TRR TSR TURTOR TOT TOX TOT Modem Parameter ConfigurationPage This space reserved for additional material Analogue In Set-up Telemetry Option ConfigurationAlarms This space reserved for additional material LED Indications OperationWait+++waitenter Appendix a AT Command CodesATS154= Command SyntaxEnd Command Mode Letter 0, not zero Ending Command Mode ATOCommands Description Values Start Command Mode Wait period set by ATS154=AT&Y8 AT&F=AT&F? AT&WATPT= ATPF?ATPRT= ATPRT?ATS168= ATS166?ATS167= ATS167?ATT? Introduction Appendix B OVER-AIR Command CodesIDS IDD 20 CH Messages from Base Station to OutstationIDS IDD 45 CH IDS IDD 51 nn tt dd ss CH Messages from Outstation to Base StationIDS IDD 65 nn cccc CH Page Appendix C ATT? Parameter String Structure