Seagate ST336807FC Performance, Reliability, Formatted capacities, Programmable drive capacity

3.3Performance

•Programmable multi-segmentable cache buffer

•200 Mbytes/sec maximum instantaneous data transfers per port

•10K RPM spindle; average latency = 3.0 msec

•Command queuing of up to 128 commands

•Background processing of queue

•Supports start and stop commands

3.4Reliability

•Annualized Failure Rate (AFR) of 0.62%

•LSI circuitry

•Balanced low mass rotary voice coil actuator

•Self-Monitoring Analysis and Reporting Technology (S.M.A.R.T.)

•Dithering

3.5Formatted capacities

Standard OEM models are formatted to 512 bytes per block. The sector size is selectable at format time. Users having the necessary equipment may modify the data block size before issuing a format command and obtain different formatted capacities than those listed.

For 2 gigabit operation, sector sizes must be divisible by 8.

To provide a stable target capacity environment and at the same time provide users with flexibility if they choose, Seagate recommends product planning in one of two modes:

1.Seagate designs specify capacity points at certain sector sizes that Seagate guarantees current and future products will meet. We recommend customers use this capacity in their project planning, as it ensures a stable operating point with backward and forward compatibility from generation to generation. The current guaranteed operating points for this product are:

	ST336807FC
Sector Size	Decimal	Hex
512	71,687,372	445DCCC
514	70,512,692	433F034
520	70,197,546	6C4CCA
522	69,731,801	42805D9
524	68,788,592	419A170

2.Seagate drives also may be used at the maximum available capacity at a given sector size, but the excess capacity above the guaranteed level will vary between 10K and 15K families and from generation to gener- ation, depending on how each sector size actually formats out for zone frequencies and splits over servo bursts. This added capacity potential may range from 0.1 to 1.3 percent above the guaranteed capacities listed above. Using the drives in this manner gives the absolute maximum capacity potential, but the user must determine if the extra capacity potential is useful, or whether their assurance of backward and for- ward compatibility takes precedence.

3.5.1Programmable drive capacity

Using the Mode Select command, the drive can change its capacity to something less than maximum. See the Mode Select Parameter List table in the SCSI Interface Product Manual. Refer to the Parameter list block descriptor number of blocks field. A value of zero in the number of blocks field indicates that the drive shall not

Cheetah 10K.7 36GB FC Product Manual, Rev. A 9