Wayne-Dalton WDSF-10, WDUSB-10R manual  , Activated

Page 20

Creating/Modifying Schedules

(continued)

5.Click on the days of week when the schedule item should occur.

6.Click on the time pull-down near the right to change the time of day when the schedule item should occur. You may also choose sunrise or sunset.

7.To enable the schedule item, make sure that the check box on the left side is checked. To disable the schedule item, un-check its check box.

8.When done, close the Schedules pop-up window.

NOTE: You may choose to let your computer go to sleep (into standby mode) when it is not used for a period of time. ThinkEssentials® will attempt to wake your computer from standby when a schedule item should occur. If your computer has trouble waking from standby mode, disable standby on your computer.

NOTE: The sun does not rise or set on certain days for

locations in the Arctic and Antarctic circles. On these days, any schedule items assigned to sunrise or sunset may not be

activated.

 

Select desired time and days of week.



Check box to ENABLE/DISABLE schedule.

Schedules

20

Image 20

Contents Package Contents USB Z-Wave Adapter USB Stand Software on CD Home Control BasicsTable of Contents Basics Copy See ReplicateBasics Number below corresponds to the bubble number above Basics 143Screen Layout Information Installation/Setup Install USB Adapter and USB stand into computer USB portNext Use Change Location link to set your physical locationAdding Modules to the Network Press ADD Device to add a Z-WavemoduleHide Pane Button or Design tab to reveal the icon Operation Common Operations Drawing Floor Plan Button in the Design pane. ThisAgain ErasePress Remove Device to remove a Z-Wavemodule Right-click and select Remove Broken Device Remove/Replace Broken ModulesTo remove the module from Use the following procedure to lock/unlock ThinkEssentials Locked mode the softwareOperations Locking/Unlocking ThinkEssentialsScenes/Zones To include modules into this scene Modifying Scenes/Zones Remove Zone option respectivelySchedules Select Scene/Zone and Action desired  ActivatedLink Modify the desired fields per Instructions in the sectionPages ItemsNetwork Operations Joining ThinkEssentials to Existing NetworksInitiate Primary Controller to Send Replication ExamplePrimary Controller Press ADD Device to add a secondary controller Adding a Controller To the networkSecondary Controller Device removed successfully message window Updating Secondary Controllers Polling Advanced OperationsOptimize/Repair Network Transfer Primary Role From Thinkessentials Initiate Transfer in ThinkEssentialsExample Portable Controller Confirmation of successful transferOn Settings tab, select Switch to or Join Controller Shift commandTransfer Primary Role To Thinkessentials CONTROLLER, or Controller ShiftBackup Network Settings ConfigurationRestore command Click the Backup or Restore Network Settings linkBackup file Wayne-Dalton USB Z-WaveLocated. Note The default parent directory is Command line windowSection on the Settings tab Before you begin, you must ExitModify the Target , then click on APPLY, then OK Adding Command Line Option to ThinkEssentials ShortcutStart ThinkEssentials using the ThinkEssentials icon Command Line Option Multiple Z-WaveUSB Adapters Initiate command line functionType in the /multi command line option ThinkEssentials /multiInitiate command line function Shortcuts Press F5 to refresh and poll the networkExiting/Closing Factory Reset Resetting ThinkessentialsTo reset the USB Z-Wave Adapter Again On the Settings tab, click on the Reset linkTroubleshooting It is enabled on the desired days of week If the modules’s icon is covered by a redThen select the module again Some modules do not supportSet up your network again Check to make sure that there is powerSwitched on Controller to my network. Now, neitherCompliance US and Foreign Patents pending