Wayne-Dalton WDUSB-10 Factory Reset, Resetting Thinkessentials, To reset the USB Z-Wave Adapter

Page 38

Resetting Thinkessentials®

Use the following procedure to reset your USB Z-Wave®Adapter to factory conditions.

WARNING: If your USB Z-Wave®Adapter and ThinkEssentials® software are the Primary Controller in a network, and you reset your USB Z-Wave®Adapter, you will no longer be able to add or remove modules from your network without recreating the entire network.

To reset the USB Z-Wave® Adapter:

1.Switch to the SETTINGS tab, and then click the RESET USB ADAPTER TO FACTORY DEFAULTS link.

NOTE: If the USB Z-Wave®adapter is serving as a secondary controller, remove it from the network by clicking the RECEIVE UPDATE FROM PRIMARY CONTROLLER link and instructing the Primary Controller to remove the USB Z-Wave®adapter. This may be referred to as REMOVE DEVICE, REMOVE CONTROLLER, EXCLUDE DEVICE, or EXCLUDE CONTROLLER.

NOTE: If you reset your Primary Controller before removing all the Z-Wave®modules from your network, you must reset each of the modules (see “Removing modules from the network”, page 13) before adding modules to the network

again.

	

On the SETTINGS tab, click on the RESET link.

Factory Reset

38

Image 38

Contents Package Contents USB Z-Wave Adapter USB Stand Software on CD Home Control BasicsTable of Contents Basics Copy See ReplicateBasics Number below corresponds to the bubble number above Basics 143Screen Layout Information Installation/Setup Install USB Adapter and USB stand into computer USB portNext Use Change Location link to set your physical locationAdding Modules to the Network Press ADD Device to add a Z-WavemoduleHide Pane Button or Design tab to reveal the icon Operation Common Operations Again Drawing Floor PlanButton in the Design pane. This ErasePress Remove Device to remove a Z-Wavemodule Right-click and select Remove Broken Device Remove/Replace Broken ModulesTo remove the module from Operations Use the following procedure to lock/unlock ThinkEssentialsLocked mode the software Locking/Unlocking ThinkEssentialsScenes/Zones To include modules into this scene Modifying Scenes/Zones Remove Zone option respectivelySchedules Select Scene/Zone and Action desired  ActivatedPages LinkModify the desired fields per Instructions in the section ItemsNetwork Operations Joining ThinkEssentials to Existing NetworksInitiate Primary Controller to Send Replication ExamplePrimary Controller Press ADD Device to add a secondary controller Adding a Controller To the networkSecondary Controller Device removed successfully message window Updating Secondary Controllers Polling Advanced OperationsOptimize/Repair Network Example Portable Controller Transfer Primary Role From ThinkessentialsInitiate Transfer in ThinkEssentials Confirmation of successful transferTransfer Primary Role To Thinkessentials On Settings tab, select Switch to or JoinController Shift command CONTROLLER, or Controller ShiftBackup Network Settings ConfigurationBackup file Restore commandClick the Backup or Restore Network Settings link Wayne-Dalton USB Z-WaveSection on the Settings tab Located. Note The default parent directory isCommand line window Before you begin, you must ExitModify the Target , then click on APPLY, then OK Adding Command Line Option to ThinkEssentials ShortcutStart ThinkEssentials using the ThinkEssentials icon Type in the /multi command line option Command Line Option Multiple Z-WaveUSB AdaptersInitiate command line function ThinkEssentials /multiInitiate command line function Shortcuts Press F5 to refresh and poll the networkExiting/Closing To reset the USB Z-Wave Adapter Factory ResetResetting Thinkessentials Again On the Settings tab, click on the Reset linkTroubleshooting Then select the module again It is enabled on the desired days of weekIf the modules’s icon is covered by a red Some modules do not supportSwitched on Set up your network againCheck to make sure that there is power Controller to my network. Now, neitherCompliance US and Foreign Patents pending