Wayne-Dalton WDSF-10, WDUSB-10R manual Adding Command Line Option to ThinkEssentials Shortcut

Page 33

Adding Command Line Option to

ThinkEssentials® Shortcut

Use the following procedure to add a command line option to your ThinkEssentials® shortcut.

Command line options (other than latitude and longitude) used with ThinkEssentials® must be initiated each time ThinkEssentials® is started. To make your command line option easier to start and permanent, you can add it to your Windows shortcut icon on your desktop.

1.Right-click on the shortcut icon for ThinkEssentials® on your desktop and select PROPERTIES. The Properties window for the shortcut will open.

2.Under the shortcut tab, you will see an are that says “Target” and this will list the exact directory location of the ThinkEssentials® file within quotation marks. Modify the target by adding the command line variables after the last quotation mark.

If there is more than one command line option to be added, they are added in the same fashion, one after another, with a leading space.

3.Click APPLY, then OK, and the “Properties” window will close.

4.Start ThinkEssentials® using the ThinkEssentials® icon.



Right-click the ThinkEssentials® icon and then select PROPERTIES.



	

Modify the Target , then click on APPLY, then OK.

Advanced Operations

33

Image 33

Contents Home Control Basics Package Contents USB Z-Wave Adapter USB Stand Software on CDTable of Contents Copy See Replicate BasicsBasics Basics 143 Screen Layout InformationNumber below corresponds to the bubble number above Install USB Adapter and USB stand into computer USB port Installation/SetupUse Change Location link to set your physical location NextPress ADD Device to add a Z-Wavemodule Adding Modules to the NetworkHide Pane Button or Design tab to reveal the icon Operation Common Operations Button in the Design pane. This Drawing Floor PlanAgain ErasePress Remove Device to remove a Z-Wavemodule Remove/Replace Broken Modules To remove the module fromRight-click and select Remove Broken Device Locked mode the software Use the following procedure to lock/unlock ThinkEssentialsOperations Locking/Unlocking ThinkEssentialsScenes/Zones To include modules into this scene Remove Zone option respectively Modifying Scenes/ZonesSelect Scene/Zone and Action desired SchedulesActivated  Modify the desired fields per Instructions in the section LinkPages ItemsJoining ThinkEssentials to Existing Networks Network OperationsExample Primary ControllerInitiate Primary Controller to Send Replication Adding a Controller To the network Secondary ControllerPress ADD Device to add a secondary controller Device removed successfully message window Updating Secondary Controllers Advanced Operations Optimize/Repair NetworkPolling Initiate Transfer in ThinkEssentials Transfer Primary Role From ThinkessentialsExample Portable Controller Confirmation of successful transferController Shift command On Settings tab, select Switch to or JoinTransfer Primary Role To Thinkessentials CONTROLLER, or Controller ShiftConfiguration Backup Network SettingsClick the Backup or Restore Network Settings link Restore commandBackup file Wayne-Dalton USB Z-WaveCommand line window Located. Note The default parent directory isSection on the Settings tab Before you begin, you must ExitAdding Command Line Option to ThinkEssentials Shortcut Start ThinkEssentials using the ThinkEssentials iconModify the Target , then click on APPLY, then OK Initiate command line function Command Line Option Multiple Z-WaveUSB AdaptersType in the /multi command line option ThinkEssentials /multiInitiate command line function Press F5 to refresh and poll the network ShortcutsExiting/Closing Resetting Thinkessentials Factory ResetTo reset the USB Z-Wave Adapter Again On the Settings tab, click on the Reset linkTroubleshooting If the modules’s icon is covered by a red It is enabled on the desired days of weekThen select the module again Some modules do not supportCheck to make sure that there is power Set up your network againSwitched on Controller to my network. Now, neitherUS and Foreign Patents pending Compliance