Wayne-Dalton WDUSB-10R, WDSF-10 manual Device removed successfully message window

Page 25

Removing Controllers

from the network

Use the following procedure to remove secondary controllers from a network where ThinkEssentials® is the primary controller.

It is best practice to remove a secondary controller from your network prior to re-setting it when it is no longer needed or if the secondary controller is to be reset for any reason. This procedure is similar to the procedure “Adding a Controller to the Network” (see page 24), but “Remove Device” from ThinkEssentials®.

1.From the Design tab, press the REMOVE DEVICE button. A message window will ask you to press the button on the device to remove.

2.Place the secondary controller into RECEIVE REPLICATION or COPY

FROM mode. (Please see the User Manual or Instruction Manual for the specific Z-Wave®controller being programmed for detailed programming information.)

If the operation is successful, a message window will appear stating that the device has been successfully added. Repeat this procedure if a message window states that the module failed to be included.

NOTE: For your security, the USB Z-Wave®Adapter must be within 3 feet of the controller to be removed.



Press REMOVE DEVICE to remove a secondary controller.

Example of	oN	oFF
Secondary	2	
	1
Controller	3
	3
	4
	5
	6

	INCLUDe	DeLeTe

Initiate Secondary Controller to RECEIVE REPLICATION.

Device removed successfully message window.

Network Operations

25

Image 25

Contents Home Control Basics Package Contents USB Z-Wave Adapter USB Stand Software on CDTable of Contents Copy See Replicate BasicsBasics Screen Layout Information Basics 143Number below corresponds to the bubble number above Install USB Adapter and USB stand into computer USB port Installation/SetupUse Change Location link to set your physical location NextPress ADD Device to add a Z-Wavemodule Adding Modules to the NetworkHide Pane Button or Design tab to reveal the icon Operation Common Operations Button in the Design pane. This Drawing Floor PlanAgain ErasePress Remove Device to remove a Z-Wavemodule To remove the module from Remove/Replace Broken ModulesRight-click and select Remove Broken Device Locked mode the software Use the following procedure to lock/unlock ThinkEssentialsOperations Locking/Unlocking ThinkEssentialsScenes/Zones To include modules into this scene Remove Zone option respectively Modifying Scenes/ZonesSelect Scene/Zone and Action desired SchedulesActivated  Modify the desired fields per Instructions in the section LinkPages ItemsJoining ThinkEssentials to Existing Networks Network OperationsPrimary Controller ExampleInitiate Primary Controller to Send Replication Secondary Controller Adding a Controller To the networkPress ADD Device to add a secondary controller Device removed successfully message window Updating Secondary Controllers Optimize/Repair Network Advanced OperationsPolling Initiate Transfer in ThinkEssentials Transfer Primary Role From ThinkessentialsExample Portable Controller Confirmation of successful transferController Shift command On Settings tab, select Switch to or JoinTransfer Primary Role To Thinkessentials CONTROLLER, or Controller ShiftConfiguration Backup Network SettingsClick the Backup or Restore Network Settings link Restore commandBackup file Wayne-Dalton USB Z-WaveCommand line window Located. Note The default parent directory isSection on the Settings tab Before you begin, you must ExitStart ThinkEssentials using the ThinkEssentials icon Adding Command Line Option to ThinkEssentials ShortcutModify the Target , then click on APPLY, then OK Initiate command line function Command Line Option Multiple Z-WaveUSB AdaptersType in the /multi command line option ThinkEssentials /multiInitiate command line function Press F5 to refresh and poll the network ShortcutsExiting/Closing Resetting Thinkessentials Factory ResetTo reset the USB Z-Wave Adapter Again On the Settings tab, click on the Reset linkTroubleshooting If the modules’s icon is covered by a red It is enabled on the desired days of weekThen select the module again Some modules do not supportCheck to make sure that there is power Set up your network againSwitched on Controller to my network. Now, neitherUS and Foreign Patents pending Compliance