Wayne-Dalton WDSF-10, WDUSB-10R manual Hide Pane Button or Design tab to reveal the icon

Page 9

Adding Modules to the Network

(continued)

3.The added Z-Wave®module will appear as an icon in the lower right corner of the ThinkEssentials® window. You may move these icons around by clicking and dragging them into open spaces or into rooms (see Drawing a floor plan, page 11-12.)

4.To name each icon, press-and- hold the left mouse button while hovering over the Z-Wave®module icon or right click the icon, then select the RENAME DEVICE menu option.

To view the name of a Z-Wave®module in the ThinkEssentials® window, hover over its icon with your mouse and the name will pop up automatically. If the module does not have a name, it will be named UNNAMED and the internal Z-Wave®node ID will follow in brackets.

5.Repeat Steps 1 thru 4 for each device you wish to add to the network.

	

Icon of Z-Wave®module appears in lower right corner of screen. NOTE: You may need to click the

HIDE PANE Button or DESIGN tab to reveal the icon.

Name the icon by right-clicking on the icon and selecting RENAME DEVICE.

Hover over module to see current name of module.

Unnamed modules have the name “Unnamed”.

Installation/Setup

9

Image 9

Contents Home Control Basics Package Contents USB Z-Wave Adapter USB Stand Software on CDTable of Contents Copy See Replicate BasicsBasics Basics 143 Screen Layout InformationNumber below corresponds to the bubble number above Install USB Adapter and USB stand into computer USB port Installation/SetupUse Change Location link to set your physical location NextPress ADD Device to add a Z-Wavemodule Adding Modules to the NetworkHide Pane Button or Design tab to reveal the icon Operation Common Operations Button in the Design pane. This Drawing Floor PlanAgain ErasePress Remove Device to remove a Z-Wavemodule Remove/Replace Broken Modules To remove the module fromRight-click and select Remove Broken Device Locked mode the software Use the following procedure to lock/unlock ThinkEssentialsOperations Locking/Unlocking ThinkEssentialsScenes/Zones To include modules into this scene Remove Zone option respectively Modifying Scenes/ZonesSelect Scene/Zone and Action desired SchedulesActivated  Modify the desired fields per Instructions in the section LinkPages ItemsJoining ThinkEssentials to Existing Networks Network OperationsExample Primary ControllerInitiate Primary Controller to Send Replication Adding a Controller To the network Secondary ControllerPress ADD Device to add a secondary controller Device removed successfully message window Updating Secondary Controllers Advanced Operations Optimize/Repair NetworkPolling Initiate Transfer in ThinkEssentials Transfer Primary Role From ThinkessentialsExample Portable Controller Confirmation of successful transferController Shift command On Settings tab, select Switch to or JoinTransfer Primary Role To Thinkessentials CONTROLLER, or Controller ShiftConfiguration Backup Network SettingsClick the Backup or Restore Network Settings link Restore commandBackup file Wayne-Dalton USB Z-WaveCommand line window Located. Note The default parent directory isSection on the Settings tab Before you begin, you must ExitAdding Command Line Option to ThinkEssentials Shortcut Start ThinkEssentials using the ThinkEssentials iconModify the Target , then click on APPLY, then OK Initiate command line function Command Line Option Multiple Z-WaveUSB AdaptersType in the /multi command line option ThinkEssentials /multiInitiate command line function Press F5 to refresh and poll the network ShortcutsExiting/Closing Resetting Thinkessentials Factory ResetTo reset the USB Z-Wave Adapter Again On the Settings tab, click on the Reset linkTroubleshooting If the modules’s icon is covered by a red It is enabled on the desired days of weekThen select the module again Some modules do not supportCheck to make sure that there is power Set up your network againSwitched on Controller to my network. Now, neitherUS and Foreign Patents pending Compliance