Omega Engineering OME-PIO-D96 manual Daughter Boards Comparison Table

Page 23

2.6.8Daughter Boards Comparison Table

	20-pin flat-cable	50-pin flat-cable	D-sub 37-pin
OME-DB-37	No	No	Yes
OME-DN-37	No	No	Yes
OME-ADP-37/PCI	No	Yes	Yes
OME-ADP-50/PCI	No	Yes	No
OME-DB-24P	No	Yes	No
OME-DB-24PD	No	Yes	Yes
OME-DB-16P8R	No	Yes	Yes
OME-DB-24R	No	Yes	No
OME-DB-24RD	No	Yes	Yes
OME-DB-24C	Yes	Yes	Yes
OME-DB-24PR	Yes	Yes	No
OME-DB-24PRD	No	Yes	Yes
OME-DB-24POR	Yes	Yes	Yes
OME-DB-24SSR	No	Yes	Yes

Note: There is no 20-pin flat-cable header in OME-PIO-D96. The OME-PIO-D96 has one D-sub37-pin connector and three 50 pin flat-cable headers.

OME-PIO-D96 User Manual (Ver.1.1, Mar/2003)

---- 21

Image 23

Contents User’sGuide Czech Republic CanadaMexico BeneluxOME-PIO-D96 Table of Contents Introduction FeaturesOptions SpecificationsOrder Description OME-PISO-series cost-effective generation, isolated cards PCI Data Acquisition FamilyProduct Check List Board Layout Hardware configurationRefer to DEMO1.C for demo program Enable I/O OperationI/O port Location D/I/O Architecture Make sure the initial level is High or Low Interrupt OperationINTCHAN3 Interrupt Block Diagram of OME-PIO-D96INTCHAN0/1/2/3 COUNTL++ Initialhigh, activelow Interrupt sourceInitiallow, activehigh Interrupt source Muliti Interrupt Source Read all interrupt state OME-DB-8125 Daughter BoardsOME-DB-37 OME-DN-37 & OME-DN-50OME-ADP-37/PCI & OME-ADP-50/PCI OME-DB-24P/24PD Isolated Input Board OME-DB-24R/24RD Relay Board OME-DB-24PR/24POR/24C Daughter Boards Comparison Table Pin Assignment All signals are TTL compatibleVCC GND PC’s physical slot information How to Find the I/O AddressResource-allocated information OME-PIO/PISO identification informationWSubVendor=0x80 wSubDevice=1 wSubAux=0x10 /* for PIOD96 PIODriverInitPIODriverInit&wBoards, wSubVendor,wSubDevice,wSubAux Current sinking Enable all D/I/O operation of card1 PIOGetConfigAddressSpaceEnable all D/I/O operation of card0 ShowPIOPISOwSubVendor,wSubDevice,wSubAux ShowPIOPISOSlot5 0x0A Slot6 0x08 Slot7 0x09 Slot8 0x07 Assignment of I/O AddressAddress Read Write I/O Address MapAUX data Register RESET\ Control RegisterAUX Control Register Aux Status Register INT Mask Control RegisterINV3 INV2 INV1 INV0 Interrupt Polarity Control Register7 I/O Selection Control Register Read/Write 8-bit data Register Demo program How to install software & utility?Piopiso PIOPISO.EXE for Windows DEMO1 DEMO2 DEMO3 COUNTL++ DEMO4 COUNTL++ DEMO5 CNTL1=CNTL2=CNTL3=CNTL4=0 Page WARRANTY/DISCLAIMER Temperature