Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle manual Tools Needed 8, 5/8

2-5. Shielding Gas Connection To Regulator/Flowmeter

6

5

4

Tools Needed:

1-1/8, 5/8 in

Obtain gas cylinder and chain to running gear, wall, or other stationary support so cylinder cannot fall and break off valve.

1Cap

2Cylinder Valve

Remove cap, stand to side of valve, and open valve slightly. Gas flow blows dust and dirt from valve. Close valve.

3Cylinder

4Regulator/Flowmeter

1

2

3

OR

Argon Gas

7 8

CO2 Gas

Install so face is vertical.

5 Gas Hose Connection

Fitting has 5/8-18 right-hand threads. Ob- tain and install gas hose.

6 Flow Adjust

Typical flow rate is 20 cfh (cubic feet per hour). Check wire manufacturer’s recommended flow rate.

1

2

3

ssb3.1 5/94 – ST-158 697-A

Make sure flow adjust is closed when opening cylinder to avoid damage to the flowmeter.

7CO2 Adapter

8O-Ring

Install adapter with O-ring between regulator/flowmeter and CO2 cylinder.

Obtain gas cylinder and chain to running gear, wall, or other stationary support so cylinder cannot fall and break off valve.

2-6. Shielding Gas Connections To Gas Control

1

2

Tools Needed:

1 Gas Control

2 Shielding Gas Valve Fitting

To Gun

	From Regulator/
5/8 in	Flowmeter
	ST-080 485-A

OM-884 Page 11