Multi-Tech Systems MT3410ZLX-T/2 owner manual Modem Does Not Execute the Command Line

MultiMobile Owner’s Manual

The Modem Does Not Execute the Command Line

C: Make sure you are typing ‘AT’ at the beginning of command line (and hit Enter at the end).

C: Make sure the modem is not in Data Mode. Type +++ if necessary.

C: Make sure your software is set to the same COMx port as your MT3410ZLX.

The Modem Does Not Give a Response After an AT Command Was Executed

C: The echo and/or responses may be turned off by the ATE0Q1 commands. Enable the AT&V1 to check Result Codes.

S: Use ATE1Q0 then Enter to change them back.

C: Make sure the modem is in Command Mode and not Data Mode when you type the AT command.

The Modem Gives an ‘ERROR’ Response After an AT Command was Executed

C: Make sure you did not type an invalid command.

C: Make sure your command line is 40 characters or less.

The Modem Goes Off-Hook and Disables the Telephone Line.

C: The modem may be set to auto-answer the phone when it rings.

S: Disable auto-answer by typing ATS0=0 then Enter at the command line.

38