MultiMobile Owner’s Manual
No Text Appears on the Screen in Data Mode
C: The remote modem is not echoing your typed characters.
S: Type ATE0 then press Enter at the command line. Then turn the software echo feature on.
C: Your software may not be set to use Full Duplex or the remote modem may not be set to use Full Duplex either.
C: The remote modem may be waiting for you to type a command before it will reply with text.
No Text Appears on the Screen When in Command Mode
S: If you can’t see the characters you are typing, then type ATE1 then press Enter.
The Modem Does Not Dial a Phone Number After Execution of AT Dial Command
C: If you are using touch tone dialing on a phone line that requires pulse dialing, then it may not work.
S: Use ATDT in place of ATDP.
Communications Software Dials, but Fails
C: Make sure the software dialing prefix is ATDT.
C: Make sure the software and modem are set to the same COMx port.
C: The modem may not have hung up the phone line since the last call.
S: Change to Command mode and type ATH then press Enter.
40