Multi-Tech Systems MT5634ZBAV.92 manual Appendix C Regulatory Compliance, FCC Part 15 Regulation

Page 35

Appendix C - Regulatory Compliance

Appendix C - Regulatory

Compliance

FCC Part 15 Regulation

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation.

WARNING – Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Industry Canada

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Reglement Canadien sur le matériel brouilleur.

Multi-Tech Systems, Inc. MT5634ZBA-Series User Guide

35

Image 35

Contents MultiModemZBA Global MT5634ZBA-Series MultiModemZBA Global MT5634ZBA-Series User Guide Table of Contents Index Products FeaturesIntroduction Features Products Features TableWhat Is in Your Modem Package Change the Internal Jumpers InstallationSafety Warnings Mount the FeetChanging the Voice Jumper Location of the JumpersChanging the Dial-Up/Leased-Line Jumper Connect the Modem to the Telephone Line Connect the Two-Wire Leased Line Leased Line OnlyConnect the Modem to Your PC Connect the Modem to Your PCConnect Speakers Voice Option Connect the Modem to the AC Power OutletPower-On Test Connect a Microphone Voice OptionRemoving an Old Modem Driver Install the Modem DriverInstalling the Modem Driver Using AT Commands to Configure Your Modem Configure the Modem for Your CountryUsing the Global Wizard to Configure Your Modem Modem-on-Hold Install Data Communications SoftwareAbout the Front Panel OperationOperation PhoneTools FeaturesSetup Leased-Line OperationConnecting to the Internet AT Commands, S- Registers, and Result Codes Changing the Setup Password Remote ConfigurationBasic Procedure SetupTurning Callback Security On and Off Changing the Setup PasswordCallback Security Assigning Callback Passwords and Phone Numbers Setting Callback Security Message ParityNumber-Entry Callback Calling ProceduresPassword-Only Callback Direct Connection Callback Security CommandsExtension-Entry Callback Callback Assignments Form Modem Does Not Respond to Commands TroubleshootingNone of the Indicators Light Modem Cannot Connect When Dialing Page Modem Disconnects While Online There Are Garbage Characters on the Monitor Modem Cannot Connect When AnsweringFile Transfer Is Slower Than It Should Be Data Is Being LostFax and Data Software Can’t Run at the Same Time Modem Doesn’t Work with Caller IDFax Data Rates Appendix a Technical SpecificationsTransmit Level Identify the Current Firmware Version Upgrade OverviewAppendix B Upgrading Modem’s Firmware Identify the Modem FirmwareRestore Your Parameters Download the Upgrade FileExtract the Upgrade Files Upgrade the Modem’s FirmwareFCC Part 15 Regulation Appendix C Regulatory ComplianceFCC Part 68 Telecom Canadian Limitations Notice Fax Branding StatementInternational Modem Restrictions EMC, Safety and R&TTE Directive ComplianceSouth African Statement New Zealand Telecom Warning NoticeSetup Appendix D Installing a Modem Under LinuxConnecting to a Cisco Router Console Port Appendix E Connecting to a Cisco RouterConsole Port Connections Remote ConfigurationRepair Procedures for U.S. and Canadian Customers Appendix F Warranty, Service, and Technical SupportWarranty Online Warranty Registration Service Repair Procedures for International DistributorsReplacement Parts Technical Support Index Index