MT2834ZPX Owner's Manual
COMMAND: | &En (Cont'd) |
| &E3 selects no |
| &E4 selects CTS |
| &E5 selects Xon/Xoff |
| &E6 selects Xon/Xoff not passed through. |
| &E7 selects Xon/Xoff passed through. |
| &E8 selects Enq/Ack pacing off. |
| &E9 selects Enq/Ack pacing on. |
| &E10 selects Normal Mode flow control off. |
| &E11 selects Normal Mode flow control on. |
| &E12 selects Pacing off. |
| &E13 means Pacing on. |
| &E14 means data compression disabled. |
| &E15 means data compression enabled. |
COMMAND: | %En |
VALUES: | n=0 thru 5 |
DEFAULT: | %E1 |
DESCRIPTION: |
|
| %E0 = Modem Won’t Escape. |
| %E1 = +++ Method (default setting). |
| %E2 = Break Method. |
| %E3 = Either +++ or Break Method. |
| %E4 = No "OK" Response to +++ |
| %E5 = "OK" Response to +++ |
COMMAND: | #Fn |
VALUES: | n = 0 thru 2 |
DEFAULT: | #F2 |
DESCRIPTION: |
|
| #F0 means no fallback when |
| #F1 means fallback from 33600 to 4800 bps |
| when |
| #F2 means fallback to 4800 bps from 33.6K |
| bps/fall forward if line improves (increments |
| of 2400 bps). |
COMMAND: | &Fn |
VALUES: | n = 0, 8 or 9 |
DEFAULT: | &F8 |
DESCRIPTION: |
|
| &F loads factory default values from ROM. |
| &F8 reads factory default values when &F is issued. |
| &F9 reads parameters stored in nonvolatile |
| memory when &F is issued. |
28