Multi-Tech Systems MT5634ZLX/FE manual Speaker always on

MultiMobile User Guide

M2	Speaker always on
M3	Speaker off during dialing and on until carrier present
Nn	Select negotiate handshake
N0	When originating or answering, handshake only at the communication rate specified
	by S37 register and “ATBn” and no fallback
N1 *	When originating or answering, start handshaking only at the communication
	standard specified by S37 register and “ATBn”. During handshake, fallback to a
	lower speed may occur.
On	Go on-line
O0	Return modem to a previously established state (return to data mode).
O1	Begin a retrain sequence, then return to on-line state.
O3	Issue a rate re-negotiation, then return to on-line state.
P	Enable pulse dialing (Disabled in CTR 21 approved models)
Qn	Result code display options
Q0 *	Result code enabled
Q1	Result code disabled
T	Enable tone dialing
Vn	Result code form
V0	Display result code in numeric form (see also the result code options table)
V1 *	Display result code in verbose (text) form
Wn	Select extended result code options
W0	CONNECT result code reports DTE speed. Disable protocol result codes. (See also
	the “Result Code Options Table”)
W1	CONNECT result code reports DTE speed. Enable protocol result codes.
W2 *	CONNECT result code reports DCE speed. Enable protocol result codes.
Xn	Select result codes/call progress options.
X0	Display CONNECT or “1” for all speeds. Ignore dial tone and busy tone detection.
X1	Display connect message and the modem’s data rate, and an indication of the
	modem’s error correction and data compression. Ignore dial tone and busy tone
	detection.
X2	Display connect message and the modem’s data rate, and an indication of the
	modem’s error correction and data compression. Check dial tone before proceeding
	dialing, ignore busy tone detection.
X3	Display connect message and the modem’s data rate, and an indication of the
	modem’s error correction and data compression. Ignore dial tone before proceeding
	dialing, check busy tone after making dialing.
X4 *	Display connect message and the modem’s data rate, and an indication of the
	modem’s error correction and data compression. Check dial tone and busy tone.
X5	Same as X4.
X6	Same as X4.

38 MT5634ZLX/FE