Multi-Tech Systems MT5600DSVD manual Return Online to Data Mode, Pulse Dialing, Select Register

MultiModemDSVD User Guide		4 AT Commands, S-Registers, and Result Codes
Command:	On	Return Online to Data Mode
Values:		0 or 1
Default:		None
Description:	O0 Exit online command mode and return to online data mode
		without a retrain. Normally used after a +++ escape (see
		+++AT<CR> escape sequence).
	O1	Exit online command mode and return to online data mode
		after a retrain.
Command:	P	Pulse Dialing
Values:		P, T
Default:		T
Description:		Forces pulse (non-touch-tone) dialing until a T command or
		dial modifier is received.
Command:	Qn	Result Codes Enable/Disable
Values:		n = 0 or 1
Default:		0
Description:	Q0	Enable result codes.
	Q1	Disable result codes.
Command:	Sr	Select Register
Values:		r = S-register number
Default:		None
Description:		Selects register Sr as the last register accessed. E.g., S0. The
		command AT? can then be used to read the register, and the
		command AT=n can then be used to set the register to value n.
Command: Sr=n		Set Register Value
Values:		r = S-register number; n varies
Default:		None
Description:		Set value of register Sr to n, where n is entered in decimal for-
		mat. E.g., S0=1. If the short form AT=n is used, the value is
		written to the last accessed S-register.
Command:	Sr?	Read Register Value
Values:		r = S-register number
Default:		None
Description:		Read value of register Sr and display it in 3-digit decimal for-
		mat. E.g., S2? gives the response 043. If the short form AT? is
		used, the last accessed S-register is read.
Command:	T	Tone Dialing
Values:		P, T
Default:		T
Description:		Forces DTMF (touch-tone) dialing until a P command or P dial
		modifier is received.
Command:	Vn	Result Code Format
Values:		n = 0 or 1
Default:		1
Description:	V0	Displays result codes as digits (terse response).
	V1	Displays result codes as words (verbose response).

27