N-Tron 102PC-SE user manual Connecting the Unit

Page 11

CONNECTING THE UNIT

For DCE serial devices (like a modem) use a null modem RS-232 cable to connect to the 102PC-SE. For a DTE serial device (like a computer) use a straight through RS-232 cable.

For the 10/100 Base-TX port, plug a Category 5E twisted pair cable into the RJ45 connector. Connect the other end to a PC or a network through a hub or switch. A standard straight through or cross-over Category 5E cable may be used to connect to either device. The MDIX mode of the 102PC-SE can be changed using jumper J1 on the board. By factory default the device is set up to use a straight through cable for a PC. Any N-Tron switch will automatically determine what MDIX the 102PC-SE is using and will connect it to the network.

12/1/2006

11

Image 11

Contents 12/1/2006 Table of Contents 12/1/2006 Contact Information Safety WarningsEnvironmental Safety Electrical Safety Unpacking Package ContentsCleaning DIN Rail Mounting Servicing Color Description Front PanelApplying Power Top View Grounding Techniques Connecting the Unit RS-232 Serial InterfaceSerial Cable Support FCC Statement TroubleshootingCLI Tree of Menus Set Set configurable fields Serial Configure the serial settings for the serial port s0 Recv-mail Configure incoming mail optionsSend-mail Configure outgoing mail options Show Show general and detailed information Socket Actions to take over a UDP socket Web Management Software Configuration12/1/2006 Web Management Tree of Menus General ConfigurationUser Configuration Port ConfigurationChatscript Modem ConfigurationBridge Configuration PPP ConfigurationSuccessfully. These cannot be modified Telnet ConfigurationAutodial Configuration UDP ConfigurationPOP3 Configuration Http ConfigurationSnmp Configuration Smtp Address ConfigurationSntp General Sntp Daylight Saving ConfigurationCommands Restore DefaultsEthernet to Serial Connectivity Mandatory Configuration SettingsScenario 1 Manual Dialout Commands to Setup Manual Dial-out with the 102PC-SEPrerequisites Scenario 2 Auto Dialout Using TelnetAuto Dialout Feature using UDP Mode Scenario 3 Auto Dialout Using UDPScenario 4 Remote Bridging with Modem Connection # set ppp ppp0 raw-mode enableSerial to Ethernet Connectivity Scenario 1 Manual Serial Dial-in Commands to Setup Manual Dial-In with the 102PC-SEScenario 2 Serial Auto Dial-in Using Telnet Functionality Scenario 3 Serial Auto Dial-in Using UDP# set serial s0 raw-dialout enable Scenario 4 Serial Tunneling Mode# set ip telnet raw-mode enable Using E-Mail Features Sending Text E-mails from the Command Prompt Receiving E-mails from the Command Prompt Physical KEY SpecificationsSwitch Properties Emissions and Safety ApprovalsTron Limited Warranty