N-Tron 102PC-SE user manual Applying Power Top View

Page 9

APPLYING POWER (Top View)

Unscrew & Remove the DC Voltage Input Plug from the Power Input Header

Install the DC Power Cables into the Plug (observing polarity).

Plug the Voltage Input Plug back into the Power Input Header.

Tightening torque for the terminal block power plug is 0.22 Nm/0.162 Pound Foot.

Verify the Power LED stays ON (GREEN).

Note: Only 1 power supply must be connected to power for minimal operation. For redundant power operation, V1 and V2 inputs must be connected to separate DC Voltage sources. This device will draw current from both sources simultaneously. Use 16-28 gauge wire when connecting to the power supply.

Recommended 24V DC Power Supplies, similar to: 100VAC/240VAC:

N-Tron’s NTPS-24-1.3, DC 24V/1.3A,

12/1/2006

9

Image 9

Contents 12/1/2006 Table of Contents 12/1/2006 Contact Information Safety WarningsEnvironmental Safety Electrical Safety Package Contents CleaningUnpacking DIN Rail Mounting ServicingColor Description Front PanelApplying Power Top View Grounding Techniques Connecting the Unit Serial Interface Serial CableRS-232 Support FCC Statement TroubleshootingCLI Tree of Menus Set Set configurable fields Recv-mail Configure incoming mail options Send-mail Configure outgoing mail optionsSerial Configure the serial settings for the serial port s0 Show Show general and detailed information Socket Actions to take over a UDP socket Web Management Software Configuration12/1/2006 User Configuration General ConfigurationPort Configuration Web Management Tree of MenusBridge Configuration Modem ConfigurationPPP Configuration ChatscriptSuccessfully. These cannot be modified Telnet ConfigurationAutodial Configuration UDP ConfigurationSnmp Configuration Http ConfigurationSmtp Address Configuration POP3 ConfigurationCommands Sntp Daylight Saving ConfigurationRestore Defaults Sntp GeneralEthernet to Serial Connectivity Mandatory Configuration SettingsScenario 1 Manual Dialout Commands to Setup Manual Dial-out with the 102PC-SEPrerequisites Scenario 2 Auto Dialout Using TelnetAuto Dialout Feature using UDP Mode Scenario 3 Auto Dialout Using UDPScenario 4 Remote Bridging with Modem Connection # set ppp ppp0 raw-mode enableSerial to Ethernet Connectivity Scenario 1 Manual Serial Dial-in Commands to Setup Manual Dial-In with the 102PC-SEScenario 2 Serial Auto Dial-in Using Telnet Functionality Scenario 3 Serial Auto Dial-in Using UDPScenario 4 Serial Tunneling Mode # set ip telnet raw-mode enable# set serial s0 raw-dialout enable Using E-Mail Features Sending Text E-mails from the Command Prompt Receiving E-mails from the Command Prompt Switch Properties KEY SpecificationsEmissions and Safety Approvals PhysicalTron Limited Warranty