N-Tron 102PC-SE user manual Sending Text E-mails from the Command Prompt

Sending Text E-mails from the Command Prompt

Issue the following command:
send-mail	send-mail
-t "<email #1>, <email #2>"	To: <email #1>
-c "<email #3>, <email #4>"	To:
-s "subject data"	To address not given
-d "Messagebody"	Cc:
	Cc address not given
	Subject: <enter subject here>
	Message body: Enter Ctrl+D to end mail,
	Ctrl+C to quit mail
	_

A message is then given as shown in the figure below and the email is sent only to the to-addresses(if any) and the cc-addresses(if any) entered from the command prompt. The subject and message body are also taken from the command prompt.

Login: admin Password:

logged in successfully

# send-mail -t "john.smith@bellsouth.net" -s "test" -d "Testing e-mail Features..."

OK: Mail sent

# send-mail

To: john.smith@bellsouth.net To:

To address not given Cc:

Cc address not given subject: testing

Message body: Enter Ctrl+D to end mail, Ctrl+C to quit mail Testing the e-mail features on the 102PC-SE..."

^D

OK: Mail sent

#

Notes:

1.The email is not sent to addresses pre-configured using set commands.

2.At least one address, either the to-addressor the cc-address, should be given as an alternative for sending email irectly from command prompt.

3.If the subject option is not specified and is not pre-configured using set commands, SMNP enters into interactive mode and requests a subject to be entered.

4.Type Ctrl+C to quit the email at any given time.

12/1/2006 37