N-Tron 102PC-SE user manual Troubleshooting, Support FCC Statement

Page 13

TROUBLESHOOTING

1.Make sure the (Power LED) is ON.

2.Make sure you are supplying sufficient current for the version chosen. Note: The Inrush current will exceed the steady state current by ~ 2X.

3.Verify that Link LED’s are ON for connected ports.

4.Verify cabling used between stations.

5.Verify that cabling is Category 5E or greater for 100Mbit Operation.

6.Verify that a null-modem cable is being used to connect other DCE devices to the serial port, or that a straight through cable is being used to connect a PC to the serial port.

SUPPORT

Contact N-Tron Corp. at: TEL: 251-342-2164 FAX: 251-342-6353 www.n-tron.com support@n-tron.com

FCC STATEMENT

This product complies with Part 15 of the FCC-A Rules.

Operation is subject to the following conditions:

(1)This device may not cause harmful Interference

(2)This device must accept any interference received, including interference that may cause undesired operation.

12/1/2006

13

Image 13

Contents 12/1/2006 Table of Contents 12/1/2006 Contact Information Safety WarningsEnvironmental Safety Electrical Safety Cleaning Package ContentsUnpacking DIN Rail Mounting ServicingColor Description Front PanelApplying Power Top View Grounding Techniques Connecting the Unit Serial Cable Serial InterfaceRS-232 Support FCC Statement TroubleshootingCLI Tree of Menus Set Set configurable fields Send-mail Configure outgoing mail options Recv-mail Configure incoming mail optionsSerial Configure the serial settings for the serial port s0 Show Show general and detailed information Socket Actions to take over a UDP socket Web Management Software Configuration12/1/2006 User Configuration General ConfigurationPort Configuration Web Management Tree of MenusBridge Configuration Modem ConfigurationPPP Configuration ChatscriptSuccessfully. These cannot be modified Telnet ConfigurationAutodial Configuration UDP ConfigurationSnmp Configuration Http ConfigurationSmtp Address Configuration POP3 ConfigurationCommands Sntp Daylight Saving ConfigurationRestore Defaults Sntp GeneralEthernet to Serial Connectivity Mandatory Configuration SettingsScenario 1 Manual Dialout Commands to Setup Manual Dial-out with the 102PC-SEPrerequisites Scenario 2 Auto Dialout Using TelnetAuto Dialout Feature using UDP Mode Scenario 3 Auto Dialout Using UDPScenario 4 Remote Bridging with Modem Connection # set ppp ppp0 raw-mode enableSerial to Ethernet Connectivity Scenario 1 Manual Serial Dial-in Commands to Setup Manual Dial-In with the 102PC-SEScenario 2 Serial Auto Dial-in Using Telnet Functionality Scenario 3 Serial Auto Dial-in Using UDP# set ip telnet raw-mode enable Scenario 4 Serial Tunneling Mode# set serial s0 raw-dialout enable Using E-Mail Features Sending Text E-mails from the Command Prompt Receiving E-mails from the Command Prompt Switch Properties KEY SpecificationsEmissions and Safety Approvals PhysicalTron Limited Warranty