N-Tron 102PC-SE user manual Package Contents, Unpacking, Cleaning

Page 6

Key Features

∙Serial interface supports speeds up to 115.2Kbps

∙High performance 10/100BaseT Ethernet bridge

∙High performance processor runs ARP, DHCP client, ICMP, IP, PPP, TCP, Telnet, TFTP, HTTP server, SMTP client, POP3 client, and PPP compression

∙Half duplex or full duplex support on the LAN interface

∙256 frame buffer for Ethernet bridging

∙Stores 10,000 MAC addresses

∙Automatically learns MAC addresses

∙Command line interface

∙The 102PC-SE operates on 10-30VDC

∙Housed in a steel ruggedized DIN rail enclosure, designed to withstand the most demanding industrial applications, and have been fully tested and certified at industrial environmental extremes

PACKAGE CONTENTS

Please make sure the Serial over Ethernet package contains the following items:

1.102PC-SE Protocol Converter

2.Product CD

Contact your carrier if any items are damaged.

Article I. INSTALLATION

Read the following warning before beginning the installation:

WARNING

Never install or work on electrical equipment or cabling during periods of lightning activity. Never connect or disconnect power when hazardous gasses are present.

Disconnect the power cable before removing the enclosure top.

Do not operate the unit with the top cover removed

UNPACKING

Remove all the equipment from the packaging, and store the packaging in a safe place. File any damage claims with the carrier.

CLEANING

Clean only with a damp cloth.

12/1/2006

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents 12/1/2006 Table of Contents 12/1/2006 Safety Warnings Contact InformationEnvironmental Safety Electrical Safety Package Contents CleaningUnpacking Servicing DIN Rail MountingFront Panel Color DescriptionApplying Power Top View Grounding Techniques Connecting the Unit Serial Interface Serial CableRS-232 Troubleshooting Support FCC StatementCLI Tree of Menus Set Set configurable fields Recv-mail Configure incoming mail options Send-mail Configure outgoing mail optionsSerial Configure the serial settings for the serial port s0 Show Show general and detailed information Socket Actions to take over a UDP socket Software Configuration Web Management12/1/2006 Port Configuration General ConfigurationUser Configuration Web Management Tree of MenusPPP Configuration Modem ConfigurationBridge Configuration ChatscriptTelnet Configuration Successfully. These cannot be modifiedUDP Configuration Autodial ConfigurationSmtp Address Configuration Http ConfigurationSnmp Configuration POP3 ConfigurationRestore Defaults Sntp Daylight Saving ConfigurationCommands Sntp GeneralMandatory Configuration Settings Ethernet to Serial ConnectivityCommands to Setup Manual Dial-out with the 102PC-SE Scenario 1 Manual DialoutScenario 2 Auto Dialout Using Telnet PrerequisitesScenario 3 Auto Dialout Using UDP Auto Dialout Feature using UDP Mode# set ppp ppp0 raw-mode enable Scenario 4 Remote Bridging with Modem ConnectionSerial to Ethernet Connectivity Commands to Setup Manual Dial-In with the 102PC-SE Scenario 1 Manual Serial Dial-inScenario 2 Serial Auto Dial-in Using Telnet Scenario 3 Serial Auto Dial-in Using UDP FunctionalityScenario 4 Serial Tunneling Mode # set ip telnet raw-mode enable# set serial s0 raw-dialout enable Using E-Mail Features Sending Text E-mails from the Command Prompt Receiving E-mails from the Command Prompt Emissions and Safety Approvals KEY SpecificationsSwitch Properties PhysicalTron Limited Warranty
Top Page Image Contents