Sntp General, Sntp Daylight Saving Configuration

SNTP General

∙SNTP Client: Enables/Disables the SNTP Client to contact the configured server on UDP port 123 and set the local time

Default: disable

∙Server Name: Sets the NTP server name or IP address to which the SNTP Client has to contact to update the time

Default: 127.0.0.1

∙Time Zone: Sets the time zone

Default: UTC

∙Time Zone offset: Sets the offset time from UTC

Default: +00:00 (+/-hh:mm)

∙Polling Time: Sets the polling time at which SNTP client requests the server to update the time

Default: 300 minutes

∙Daylight Saving: Enables/Disables the Day Light Saving Mode

Default: enable

∙Daylight Saving offset: Sets the offset to use during the Day Light Saving Mode

Default: +60 (+/-mm)

SNTP Daylight Saving Configuration

∙Start Ordinal: Sets the start ordinal to use during the Day Light Saving Mode. Options - first/second/third/forth/last

Default: first

∙End Ordinal: Sets the last ordinal to use during the Day Light Saving Mode. Options - first/second/third/forth/last

Default: last

∙Start Month: Sets the start month to use during the Day Light Saving Mode

Default: april

∙End Month: Sets the end month to use during the Day Light Saving Mode

Default: october

∙Start Day: Sets the start weekday to use during the Day Light Saving Mode

Default: sunday

∙End Day: Sets the end weekday to use during the Day Light Saving Mode

Default: sunday

∙Start Time: Sets the start time to use during the Day Light Saving Mode

Default: 02:00 (hh:mm)

∙End Time: Sets the end time to use during the Day Light Saving Mode.

Default: 02:00 (hh:mm)

Commands

∙User can enter any "set" commands as per the manual

View Statistics

∙Bridge: Displays the Bridge Statistics only when bridge is enabled

∙eth0: Displays Ethernet Statistics

∙serial: Displays Serial Statistics

∙PPP: Displays PPP Statistics only when PPP is enabled

∙Users: Displays the Default and Added users of the module

∙System Information: Displays the System information of the module. Processor details, Uptime, Memory utilization, Flash Memory map, Version, Date, Binary details

Save

∙ Upon clicking Save button, it prompts for confirmation

∙ If selected OK, the modified configuration is written into flash and if the box may reboot for few configuration changes. After few seconds, the default.html/http-s0.html page will be launched again as per configuration. If the page is not launched, check the IP address and HTTP configuration status

∙ If selected CANCEL, the browser is redirected to General Configuration page

Restore Defaults

∙Upon clicking Restore Defaults button, it prompts for confirmation

∙If selected OK, the configuration is restored to factory defaults and redirected to General Configuration page. User need to click save button to save the configuration

∙If selected CANCEL, the browser is redirected to General Configuration page

N-Tron 102PC-SE Sntp General, Sntp Daylight Saving Configuration, Commands, View Statistics, Save