Milan Technology MIL-S1000 user manual port 100Base-TX/FX Front View

Page 16

4 Ports 100Base-FX Fiber Module

Figure 1-8.4 port 100Base-TX/FX Front View

When installed into a MIL-S1000 switch, this Module provides 4 x 100Mbps Fast Ethernet fiber ports which can be used to:

#Connect the Switch to the backbone of your network; that is, to a basement switch, hub or router.

#Connector the Switch to a 100Mbps server or end station.

An ST, SC, MT-RJ or VF-45 connector provides the link to the multi-mode fiber cabling and three LEDs show five status of the Module at-a glance. A DIP-switch sets the operating mode to half duplex or full duplex (default).

Image 16

Contents MIL-S1000  Copyright Table of Contents Introduction Planning your NetworkInstallation Module Install and RemovedIntroduction Package Contents Device Description, Features and Capabilities MIL-S1000 Front and Rear PanelsRed Full Duplex/Col indicators Page Ports 10/100Base-Tx Module Features Ports 10/100Base-TX ModuleDIP Switch with Link Mode Dip switch location and mode settings8 Ports 10/100Base-TX Module DIP switch functions Ports 100Base-FX Fiber Module 2 port 100Base-FX Module Front ViewPorts 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Location and setting duplex mode Ports 100Base-FX Fiber Module FeaturePage 1000Base-SX/LX Fiber Module Features 1000Base-SX/LX Fiber ModuleEnable N-way Full Duplex Planning your Network 10Base-T Ethernet Network Guidelines100Base-TX Ethernet Network Guidelines 100BASE-FX Network Guidelines1000BASE-SX and LX Network Guideline Network PlanningExpanded Networks 10Base-T Networks100Base-TX Networks Expanding your 100Base-TX network ClassCollapsed Backbone Link 100Base Solution Fileserver LinkFileserver Link 1000Base Solution Multiport Bridge with High-Bandwidth BackboneUsed as a Multiport Bridge Installation Supplying Power Rack InstallationPage Connecting the Switch Module Installation and Removal Handling the ModulesModule Setup and Installation Insert the moduleInstalling 10/100Base-TX Modules Installing the ModulesInstalling 100Base-FX Modules Installing 1000Base-SX/LX Modules Removing the ModulesPhysical Characteristics Compatibility with Ethernet StandardsSwitching Architecture LED IndicatorsAddress Table Forwarding RateAppendix B. Pin Assignments Switch Adapter Hub