Milan Technology MIL-S1000 100Base-TX Ethernet Network Guidelines, 100BASE-FX Network Guidelines

Page 22

100Base-TX Ethernet Network Guidelines

#The maximum length of a 100Base-TX cable segment is 100 meters (328 feet).

#The maximum number of hubs on a 100Base-TX segment is one if using Class I hubs and two if using Class II hubs.

#The recommended cable type is EIA/TIA Category 5 unshielded twisted-pair.

#The maximum network diameter is 200 meters (656 feet) when using Class I hubs and 205 meters (672.5 feet) when using Class II hubs.

100BASE-FX Network Guidelines

#In half duplex mode, the fiber optic segment cannot exceed 412m (1,135ft) in length.

#In full duplex mode, the fiber optic segment cannot exceed 2km (6562 ft) in length.

Image 22

Contents MIL-S1000  Copyright Table of Contents Introduction Planning your NetworkInstallation Module Install and RemovedIntroduction Package Contents Device Description, Features and Capabilities MIL-S1000 Front and Rear PanelsRed Full Duplex/Col indicators Page Ports 10/100Base-Tx Module Features Ports 10/100Base-TX ModuleDIP Switch with Link Mode Dip switch location and mode settings8 Ports 10/100Base-TX Module DIP switch functions Ports 100Base-FX Fiber Module 2 port 100Base-FX Module Front ViewPorts 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Location and setting duplex mode Ports 100Base-FX Fiber Module FeaturePage 1000Base-SX/LX Fiber Module Features 1000Base-SX/LX Fiber ModuleEnable N-way Full Duplex Planning your Network 10Base-T Ethernet Network Guidelines100Base-TX Ethernet Network Guidelines 100BASE-FX Network Guidelines1000BASE-SX and LX Network Guideline Network PlanningExpanded Networks 10Base-T Networks100Base-TX Networks Expanding your 100Base-TX network ClassCollapsed Backbone Link 100Base Solution Fileserver LinkFileserver Link 1000Base Solution Multiport Bridge with High-Bandwidth BackboneUsed as a Multiport Bridge Installation Supplying Power Rack InstallationPage Connecting the Switch Module Installation and Removal Handling the ModulesModule Setup and Installation Insert the moduleInstalling 10/100Base-TX Modules Installing the ModulesInstalling 100Base-FX Modules Installing 1000Base-SX/LX Modules Removing the ModulesPhysical Characteristics Compatibility with Ethernet StandardsAddress Table Switching ArchitectureLED Indicators Forwarding RateAppendix B. Pin Assignments Switch Adapter Hub