Milan Technology MIL-S1000 user manual Module Installation and Removal, Handling the Modules

Page 35

Chapter 4. Module Installation and Removal

WARNING

Before installing the Modules into a MIL-S1000, you must disconnect the Switch from the main power supply.

Handling the Modules

The Module can be easily damaged by electrostatic discharge. To prevent damage, please observe the following:

#Do not remove Modules from their packaging until you are ready to install it into a Switch.

#Do not touch any of the pins, connections or components on the Modules.

#Handle the Modules only by its edges and front panel.

#Always wear an anti-static wristband connected to a suitable grounding point.

#Always store or transport Modules in appropriate anti- static packaging.

Image 35

Contents MIL-S1000  Copyright Planning your Network Table of Contents IntroductionModule Install and Removed InstallationIntroduction Package Contents MIL-S1000 Front and Rear Panels Device Description, Features and CapabilitiesRed Full Duplex/Col indicators Page Ports 10/100Base-TX Module Ports 10/100Base-Tx Module FeaturesDip switch location and mode settings DIP Switch with Link Mode8 Ports 10/100Base-TX Module DIP switch functions 2 port 100Base-FX Module Front View Ports 100Base-FX Fiber ModulePorts 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Ports 100Base-FX Fiber Module Feature Location and setting duplex modePage 1000Base-SX/LX Fiber Module 1000Base-SX/LX Fiber Module FeaturesEnable N-way Full Duplex 10Base-T Ethernet Network Guidelines Planning your Network100BASE-FX Network Guidelines 100Base-TX Ethernet Network GuidelinesNetwork Planning 1000BASE-SX and LX Network Guideline10Base-T Networks Expanded NetworksExpanding your 100Base-TX network Class 100Base-TX NetworksCollapsed Backbone Link Fileserver Link 100Base SolutionFileserver Link Multiport Bridge with High-Bandwidth Backbone 1000Base SolutionUsed as a Multiport Bridge Installation Rack Installation Supplying PowerPage Connecting the Switch Handling the Modules Module Installation and RemovalInsert the module Module Setup and InstallationInstalling 100Base-FX Modules Installing the ModulesInstalling 10/100Base-TX Modules Removing the Modules Installing 1000Base-SX/LX ModulesCompatibility with Ethernet Standards Physical CharacteristicsForwarding Rate Switching ArchitectureLED Indicators Address TableAppendix B. Pin Assignments Switch Adapter Hub