Milan Technology MIL-S1000 user manual Removing the Modules, Installing 1000Base-SX/LX Modules

Page 38

Installing 1000Base-SX/LX Modules

a.Remove the protective plastic covers from the fiber connectors on the Module.

b.Ensure that the Switch is powered up.

c.Plug the SC connector on the fiber cable into the fiber socket on the Module.

d.Connect the other end of the fiber optic segment to an appropriate device fitted with a 1000Mbps adapter.

Check the LED indicators on the front of the Switch to ensure that the Module is operating correctly.

Removing the Modules

a. Ensure that the power supply and the backbone connection cables are disconnected from the Switch.

b.Place the Switch on a flat surface. Undo the two captive thumbscrews securing the Module into the Switch. Do not remove any other screws from the rear of the Switch.

c.If you are not installing another Module immediately, you must replace the blanking plate to ensure that dust and debris do not enter the Switch, as well as to aid circulation of cooling air.

Image 38
Contents MIL-S1000  Copyright Table of Contents Introduction Planning your NetworkInstallation Module Install and RemovedIntroduction Package Contents Device Description, Features and Capabilities MIL-S1000 Front and Rear PanelsRed Full Duplex/Col indicators Page Ports 10/100Base-Tx Module Features Ports 10/100Base-TX ModuleDIP Switch with Link Mode Dip switch location and mode settings8 Ports 10/100Base-TX Module DIP switch functions Ports 100Base-FX Fiber Module 2 port 100Base-FX Module Front ViewPorts 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Location and setting duplex mode Ports 100Base-FX Fiber Module FeaturePage 1000Base-SX/LX Fiber Module Features 1000Base-SX/LX Fiber ModuleEnable N-way Full Duplex Planning your Network 10Base-T Ethernet Network Guidelines100Base-TX Ethernet Network Guidelines 100BASE-FX Network Guidelines1000BASE-SX and LX Network Guideline Network PlanningExpanded Networks 10Base-T Networks100Base-TX Networks Expanding your 100Base-TX network ClassCollapsed Backbone Link 100Base Solution Fileserver LinkFileserver Link 1000Base Solution Multiport Bridge with High-Bandwidth BackboneUsed as a Multiport Bridge Installation Supplying Power Rack InstallationPage Connecting the Switch Module Installation and Removal Handling the ModulesModule Setup and Installation Insert the moduleInstalling 100Base-FX Modules Installing the ModulesInstalling 10/100Base-TX Modules Installing 1000Base-SX/LX Modules Removing the ModulesPhysical Characteristics Compatibility with Ethernet StandardsAddress Table Switching ArchitectureLED Indicators Forwarding RateAppendix B. Pin Assignments Switch Adapter Hub