Milan Technology MIL-S1000 user manual Module Setup and Installation, Insert the module

Page 36

Module Setup and Installation

1.Ensure that the Switch is disconnected from the main power supply and that you are wearing an anti-static wrist-band connected to a suitable grounding point.

2.Place the Switch on a flat surface. Using a small cross- bladed screwdriver, remove the blanking plate from the rear of the Switch. Do not remove any other screws from the rear of the Switch.

3.Keep the blanking plate and screws in a safe place. If you remove the Module at any time, you must replace the blanking plate to prevent dust and debris from entering the Switch and to aid the circulation of cooling air.

4.Hold the Module so that the text on the front panel is oriented correctly, and insert it into the Switch, ensuring the connectors are fully engaged. Tighten the two captive thumbscrews that secure the Module in place.

Figure 4-1.Insert the module

Image 36

Contents MIL-S1000  Copyright Table of Contents Introduction Planning your NetworkInstallation Module Install and RemovedIntroduction Package Contents Device Description, Features and Capabilities MIL-S1000 Front and Rear PanelsRed Full Duplex/Col indicators Page Ports 10/100Base-Tx Module Features Ports 10/100Base-TX ModuleDIP Switch with Link Mode Dip switch location and mode settings8 Ports 10/100Base-TX Module DIP switch functions Ports 100Base-FX Fiber Module 2 port 100Base-FX Module Front ViewPorts 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Location and setting duplex mode Ports 100Base-FX Fiber Module FeaturePage 1000Base-SX/LX Fiber Module Features 1000Base-SX/LX Fiber ModuleEnable N-way Full Duplex Planning your Network 10Base-T Ethernet Network Guidelines100Base-TX Ethernet Network Guidelines 100BASE-FX Network Guidelines1000BASE-SX and LX Network Guideline Network PlanningExpanded Networks 10Base-T Networks100Base-TX Networks Expanding your 100Base-TX network ClassCollapsed Backbone Link 100Base Solution Fileserver LinkFileserver Link 1000Base Solution Multiport Bridge with High-Bandwidth BackboneUsed as a Multiport Bridge Installation Supplying Power Rack InstallationPage Connecting the Switch Module Installation and Removal Handling the ModulesModule Setup and Installation Insert the moduleInstalling the Modules Installing 10/100Base-TX ModulesInstalling 100Base-FX Modules Installing 1000Base-SX/LX Modules Removing the ModulesPhysical Characteristics Compatibility with Ethernet StandardsSwitching Architecture LED IndicatorsAddress Table Forwarding RateAppendix B. Pin Assignments Switch Adapter Hub