Milan Technology MIL-S1000 user manual Enable N-way Full Duplex

Page 20

D IP S w itch Location

H alf D uplex

 

D IP 2

 

 

FullD uplex

N

 

 

 

2

 

FF

 

 

 

 

O

 

 

 

1

 

O

D isable N -w ay

 

D IP 1

Enable

N -w ay

Figure 1-11.Location and setting duplex mode

If you adjust to Enable N-Way, then the DIP for Half-Duplex and Full-Duplex is not effective. If you adjust to Disable N- Way, then the DIP for Half-Duplex and Full-Duplex is effective.

The following Table 1-4. lists the ports’ operating modes based on the DIP switch position.

Gigabit Port

SW

1

2

ON

Disable N-way

Half Duplex

OFF

Enable N-way

Full Duplex

Table 1-4.1000Base-SX/LX Fiber Module DIP switch functions

Image 20
Contents MIL-S1000  Copyright Table of Contents Introduction Planning your NetworkInstallation Module Install and RemovedIntroduction Package Contents Device Description, Features and Capabilities MIL-S1000 Front and Rear PanelsRed Full Duplex/Col indicators Page Ports 10/100Base-Tx Module Features Ports 10/100Base-TX ModuleDIP Switch with Link Mode Dip switch location and mode settings8 Ports 10/100Base-TX Module DIP switch functions Ports 100Base-FX Fiber Module 2 port 100Base-FX Module Front ViewPorts 100Base-FX Fiber Module Features Page 4 port 100Base-TX/FX Front View Location and setting duplex mode Ports 100Base-FX Fiber Module FeaturePage 1000Base-SX/LX Fiber Module Features 1000Base-SX/LX Fiber ModuleEnable N-way Full Duplex Planning your Network 10Base-T Ethernet Network Guidelines100Base-TX Ethernet Network Guidelines 100BASE-FX Network Guidelines1000BASE-SX and LX Network Guideline Network PlanningExpanded Networks 10Base-T Networks100Base-TX Networks Expanding your 100Base-TX network ClassCollapsed Backbone Link 100Base Solution Fileserver LinkFileserver Link 1000Base Solution Multiport Bridge with High-Bandwidth BackboneUsed as a Multiport Bridge Installation Supplying Power Rack InstallationPage Connecting the Switch Module Installation and Removal Handling the ModulesModule Setup and Installation Insert the moduleInstalling 100Base-FX Modules Installing the ModulesInstalling 10/100Base-TX Modules Installing 1000Base-SX/LX Modules Removing the ModulesPhysical Characteristics Compatibility with Ethernet StandardsSwitching Architecture LED IndicatorsAddress Table Forwarding RateAppendix B. Pin Assignments Switch Adapter Hub