Liebert RAC2-8 manual TB2

Page 43

Section 5: Installation

Interface Board 4C13521G

(Located in the DataMate, mini-MATE, or mini-MATE Plus)

3.Using wire cutters, carefully snip and remove the C5 capacitor at the K5 common alarm on the interface board. Refer to the diagram below for the location of the C5 capacitor.

K8
K7	P2
	4
K6	3
K6	2
RV4	1

	R5	TB2
K5	C5 (yellow)
	CR7

RV5

P1	TB1

38 • User Manual (9/97)

Image 43

Contents $XWRð&KDQJHRYHUý&RQWUROOHU Table of Contents Table of Figures Unit RAC2-8Page Introduction Page To start up the RAC2-8 InstallationOperation Page Glossary of Control Functions for more details OperationStatus Sub-menu Sequencing Status Screens cont’dUnits DelaySet Options Sub-menu Status Sub-menu cont’dSet Options Sub-menu cont’d Function Delays TEMP/HUM Standby PasswordAlarm Sub-menu DAY of Week Set Clock Sub-menuDate TimeUnit 01 Forced on Force OFF Restore Return LOG on TerminalStatus Screen Unit Status Setup Zones/Units OptionsSetup Zones/Units Options cont’d Number of ZONES/NUMBER of Units PER ZoneEmergency Power Units Unit Shutdown on Alarm08 0 no Unit Labels Alarms Review and Alarms ClearSet Clock Override a Unit Set Modem Options Setup Temp/Humid Options cont’d Setup Temp/Humid OptionsSet Modem Options cont’d Setup Standby Unit Options Set New Password Display SS Alarm BlockList of Alarms AlarmsAutochangeover Alarm AnnunciationAlarm Communications Alarm DelayAutosequencing Key Clear AlarmsCommon Alarm-Inputs Common Alarm-OutputHold Delay DelayEmergency Power OFF EPO Emergency Power OperationInterval Humidity AlarmsHumidity Lockout Inactive UnitOverride Normal TemperaturePassword Power Failure ModeRunning Units Restart DelayRestore Standby TestingTerminal Temperature AlarmsTemperature Sensitivity Temperature StagingZones Installation TB2 RAC2-8 Dimensional Enclosure Diagram RAC2-8 Component Arrangement RAC2-8 Connection Diagram RAC2-8 Switch and Jumper Settings

TB2

TB1